Voltage: 4.5 - 6v
Running Current: 180mA
Spline Count : 21 Tooth
Narrow dead band width.
Unit Weight (g):
Not satisfied, servo has a quite some gear slack. As a result my elevons have a wobble of up to 4mm. As stated below, not full metal gear. Would not use on an airplay. But ok for the price I guess.Dissapointed by the servo arms . They are shorter and lighter than some I have off a " mini "servo . They certainly dont suit a " high torque " servo , and Im not sure if Im going to be able to use this servo because of this . Looks okay otherwise .Gear aren't 100pcnt metal, 1 gear is plastic, so the weak point of this servo. I don't know why put metal gear when one of them is plastic! Screw is to fix arm is very very small, hard to use with a servo saver.This servo is a great drop-in replacement for the Hitec 225MG. Slightly less torque but plenty of power for my application and a bit lighter to boot. Absolutely a great value at a fraction of the price of the Hitec.Strong, hardcore, precise servo. Bang for the buck. I installed these in a Addiction X. Superb control. A little but power hungry servo but with the voltage protector. Nothing to worry about. Excelent choice against the hitec HS85MGIt works ok, but it is just a cheap servo. It has some gearplay, but centering, speed and torque are good enough for some plane models where a 9 gram servo is too weak and a standard servo too big, and if you have to look at the price. I opened one, and due to this, i would never use this servo in a heli or in a plane model with a glow engine. But it is a good servo for some electric powered plane models, and it needs not much power. For the price, it is a good and useful servo.they work well, strong, but one of mine had the motor wire broken, luky of mine it was a aileron servo and it broke wile it was in neutral position, the other aileron did the work perfectly (I didi´t even notice it during the fligth).
It´s a good Idea to open it and check for the soldering in the wires.I bought two for the v tail of a Salangane glider. They are okay but there is too much slop for my liking it accounts for about 2mm slop at the control surface. Good value, but I'll try to buy a better servo next time.Nice small servo that I used in a 1/10th oval pan car. Normal size servo savers won't work on this servo though.Ce n' est pas un servo digital mais analogique !!!
Caution it's not a digital servo only analogic