Turnigy Alloy case, Titanium gear, High-voltage servo with dual large bearings.
Servos dont get better than this!
The Turnigy HV-Servos are the best bang-for-buck in the high performance servo category. Guaranteed!
Why waste money on over-marketed big brand servos!? Trust Turnigy to deliver more than the required performance for your heli or plane.
Super eCCPM / High speed Cyclic servo use only.
Dead band: 0.0008 ms (Default)
Control System: +Pulse Width Control
Working frequence: 1520μs / 333hz
(RX) Required Pulse: 3.5 ~7.4 Volt Peak to Peak Square Wave
Operating Voltage: 8.4 ~12.0 V DC Volts
Operating Temperature Range: -10 to + 60 Degree C
Operating Speed (8.4V): 0.180 sec/60° degrees at no load
Operating Speed (12V): 0.130 sec/60° degrees at no load
Stall Torque (8.4V): 26.90 kg.cm (373.6 oz/in)
Stall Torque (12V): 38.40 kg.cm (533.3 oz/in)
360° Modifiable: NO
Motor Type: Coreless Motor
Potentiometer Drive: Indirect Drive
Driver Type: FET
Bearing Type: Dual Ball Bearings
Gear Type: Titanium Gears
Connector Wire Length: 15.0 cm (5.9 in)
Dimensions: 40X20X45 mm (1.57x0.97x1.77 in)
Weight: 78.5g (2.77 oz)
Unit Weight (g)
j'ai mont ses servos sur un yak 55M de 2.20m aliment par nano-tech de 3000 3s 11v, quel puissance . trs satisfait de se produit, je les recommande pour un avion de voltige de 2.80m est plus. excellent servos.this one is not doing to well in my rc8b, steering. the one in throttle is doing great but the steering one cuts on and off for no apparent reason, not hot, not binding, servo saver is loose but it still sticks every other lap and won't center until i manually center it, then it works fine for another couple laps.
i guess something may be loose inside electronically cause all the gears are clean and smooth still. bummer cause im trying to convince out lhs to carry these also. times are tough and a good budget servo can help keep more people at the track.very strong servo, the best i have ever seen, i use it on my savage for steering in trial use.
This servo has resolution, power and speed similar to my favorite H*tec 5955s. Time will tell if they hold up as well. So far 5 stars for value.i have buyed this for ait force one and it was a great replacement part for the joystick