Turnigy L2206A-1650 Brushless Motor (120w)Specifications:
Dimension: 28mm x 21mm
Weight: 36g (50g with all fittings, connectors & prop driver)
Voltage: 7.2v~11.1v (2s~3s)
Max Power: 120w
Max Current: 17.8A
No load Current: 0.9A
Diameter of shaft: 3mm
Max Currents (A)
Length B (mm):
Can Length D(mm)
Unit Weight (g):
Total Length E(mm)
The motor has burnt after 10 seconds at full power on 3s and 8x6, before its first flght.
Really bad or unlucky.Es perfecto para mi YACK 55. Cayo al mar, se rompio toda la electronica del avion y repongo el mismo motor sin dudasExcellent engine I use on a zagi 1.2 meters with 1300 mah battery, weight 510 grams. Excente engine with exellent autonomy.best rate best priceThis motor was recommended to me by Hobby King tech support to replace the stock motor 1850 kv that came with my Radjet 800. My stock motor ran very well with plenty of power to properly fly the Radjet 800 until I broke the shaft in a rough landing. This recommended replacement motor only 1650 kv runs fine except it doesn't develop enough rpm's to fly my Radjet 800. I am using a 1300 mAh 11.1v Lipo with a 30 amp esc.Nice packed.
Only 3 stars because after fixing it on my wood motor mount for my mdm1 FOX, I have noticed that this little boys makes BIG vibrations. I don't know If It will be usable...Perfect engine manufacture and fantastic performance. I recommend to anyone who needs a light engine with 150 wattSolid quality motor that works. I like the included stuff, saves me few bucks.This is a great little motor for the price. Its light weight, powerful, and very quiet. On my scratchbuilt biplane with an 8x4 apc prop it just silently humms along.
The quality is a little lacking though. After 4 or 5 flights without a rough landing the motor began to have trouble getting started, it turns out that the connectors on 2 of the wires were not soldered properly.
Overall this is a good motor for the price and I highly recommend it, just double check the pre-soldered bullet connectors before you fly.i purchased this motor n tried it with 18 amp esc. after 3 attempts it shopped. i checked all the wired, they were fine. did it burned?
also suggest prop for this motor, as i am new to rc