Charging your fleet of micro batteries just got easier with the Turnigy Micro-6.
The Micro-6 is setup to specifically charge micro batteries with 6 independent ports and a 3 digit LED voltage display.
Charging micro batteries can be difficult on some larger chargers because they're setup for higher capacity packs and may not charge your micro battery fully resulting in shorter run times.
With this handy little charger you simply plug it into a PC or USB wall plug. It can run off a DC power supply if you are able to restrict the power output to 6V.
• 6 independent ports can be used at the same time
• Each port can be used as battery voltage checker
• 3-digital LED displays battery voltage
USB Input: 5V/2.1A
DC Input: 6V
DC Input Current: 2A or above
Port 1~4 charge current: 350mA
Port 5~6 charge current: 500mA
Battery: 1S (3.7V) LiPo
Battery Connector: Micro
Temperature range: 0~50c
Size: 76mm x 63mm x 22.8mm
For small 1S battery is very convenient and reduce the charging time, because of the charging current limit, if the capacity over 500ma or more, charging time is a bit slow, using a general RC charger would be more appropriate.
When charging, the voltage meter value is not correct, dont worry , just waiting for the green light when the charging is completed, or you can get the correct value by pressing stop charging.
Convenient，Easy to use , Good price~ Recommendwhats this about it all being revere plority for tuirnigy batteries that ive read in this comment section ,is this charger safe to use or not as i dont want to plug into my expensive power supply and fry the lot ,can anyone give any correct info ,im wanting to charge batteries for the blade inductrix fpvNice little charger, does just what it says it will. I've been using it with "1S Female to Losi Male" adapter cables from rc-connectors.com to charge 4 Inductrix batteries at a time. Their adapters are a little pricey, but worth it in my opinion (nicely made). The plugs need to be assembled with the correct polarity, which should not be done by someone who is uncomfortable checking their work with a volt meter!
Only 4 of the 6 charger outputs are low enough current for charging Inductrix batteries, though I believe it is possible to hack the remaining two circuits to lower their current. I thought I saw someone talking about that here, but I can no longer find their thread.Nice 1s battery charger for indoor racing drone, there are four 350ma charge ports and two 500ma ports, charging speed is slow, however, 6x battery charging at same time is satisfied.
ATTENTION: the connector are walkera connectors.This is a great little charger. 6 total ports using 4 350ma ports and 2 500ma ports. You can plug it into a computer or power cell and charge batteries or use a power supply @6v. Cant go wrong with this for especially smaller batteries. I use it for my 1s 3.7v 750mah batteries for my Syma X5SW. Works great.I am liking this little charger for the micro heli batteries. USB powered, so could use in the field from a battery bank etc, and has a voltage display and two fixed charge rates depending on the port you plug into. charges each battery individually or all together. perfect. and so cheap.! Easy to use.
charges 4 batts at 350mA and 2 at 500mA (verified with an external meter). very neat solution. must have.A Turnigy loader? There are no Turnigy Lipos on the market which are connectable. You changed all 6 ports PLUS with MINUS. That is a full short people!!!! PLEASE DO STOP SELLING! PEOPLE BURNT THERE FINGERS AND LIPOS WILL EXPLODE!! ALSO POWERSupply explode or burn!!!