The Turnigy Multi-Rotor Power Distribution Board has been designed for multi-copters within the 250 - 300mm size range. This is a versatile as well as a great value product for multi-rotor builders and is suitable for up to six ESCs within the 6-10Amp range.
• Connect up to 6 ESCs (6 ~ 10A)
• Independent 5 v output for the use of receiver
• Independent 12 v output for the use of FPV
• Two sets of mounting holes 30mm*30mm or 44mm*44mm.
Load capacity: 60A max
Power cord length: 150mm
PCB Size: 50mmx50mm
- Blade Count:
ingombrante.se ci fosse quella solo con i 4 esc sarebbe il topLove this board so much that I bought two more for future builds. The 2mm banana plug jacks make this a very clean install. I soldered 2mm male banana plugs to the leads from the ESCs and just plug them into the power distribution board. Reconfiguring is a snap since I don't have to de-solder the power board. The two BECs are great for powering accessories like lights or switches.These are great! I built a 250-size quadcopter and this made assembly a breeze. It has both 12v and 5v BECs configured for three-pin servo connectors. To connect my ESCs, I simply soldered 2mm male bullet connectors to the positive and negative leads and then just plugged them in. I'm buying several more for future multirotor builds. It has six ESC plug sets, so it will power up to a hexacopter.