Turnigy™ has recognized the Mobius ActionCam as the go-to camera for RC enthusiasts and set out to make a low cost, light weight, quality component 2-Axis gimbal to match the Mobius’s smaller size.
Design of the Turnigy™ Mobius gimbal started with the popular AX 2206 BLGM Brushless motor, perfect for its small size and is well known as a great motor. From there Turnigy had the motors custom made to match their spec.
Turnigy™ then set out to create a lightweight and robust frame around the Mobius and your chosen hardware which is compatible with the Quanum Nova and DJI Phantom Quadcopters.
The result is one of best gimbals available for the user that wants the flexibility of choosing their own controller and best of all it’s made specifically for the Mobius.
• Light Weight
• AX2206 Gimbal motors
• Roll and pitch control
• Adjustable axis position
• ALL CNC Aluminium and composite frame
Size: HxWxL 76x67x100mm max all around size
Weight: 160g (including motors)
Motor Specs Turnigy ™ AX2206:
Bottom holes center to center: 16mm and 19mm
Top holes center to center: 12mm
Mount Frame and fasteners
Vibration damping balls
Controller mounting board
2 Turnigy ™ AX2206 brushless outrunner motors
Note: This is a Kit and does require some assembly.
Note: Please pay close attention to the bolt locations in the instructions, and note the pitch motor uses the two 6mm bolts, if the 8mm bolts are used could damage the motor windings causing the pitch axis to shake when powered.
Note: Camera and Controller Not Included
This will mount to the Deluxe Crab gear (450000098-0). The instructions show the standoffs mounted in line with the holes where the two M2.5 screws go; use the other two outer holes instead. With this configuration the gimbal will mount in the forward two slots on the smaller (rectuangular) CF plate that comes with the crab gear.
I have not tested the unit - I haven't got the controller board yet (Tarot ZYZ22 GOPRO) but as others have noted this gimbal comes with standard servo connectors. To mount it to the Tarot board you will need to change the connectors or solder the wires directly to the board.For the second time the send me the gimbal with the rong connectors.
The photo shows small connectors and the send big jst connectors and the dont fit in to a control tarot control boardConsidering this is for a Mobius (or RunCam?), you can't beat the price. There are not a lot of Mobius/RunCam gimbals out there and those that I do find are higher in price. Have used a couple AlexMos/BaseCam controllers with this gimbal yielding reasonable results, but I had to spend a bit of time with the BaseCam GUI software to calibrate and configure the controllers I used. I may buy another one.La especificacion del anuncio es nefasta y cuando tienes una reclamacion el sistema es lento, malo y muy confuso.product as described at a very nice price