*IN STOCK NOW!
The Walkera QR X350 revolutionized the multi-rotor market upon its release in 2013 by bringing GPS stabilized mutli-rotor flight to the R/C market at an affordable price. Walkera is breaking the rules again in 2014 with the release of the all new QR X350 PRO, which boasts a whole host of new features and optimization for aerial video/FPV use.
The all new Walkera QR X350 PRO provides astonishing 25 minute flight times on the stock power system, features the all new DEVO-M flight controller providing improved stability/GPS position holding and also is "Plug and Play" compatible with Walkera's G-2D brushless camera gimbal.
The QR X350 PRO has an enhanced altitude sensor which adopts GPS technology allowing it to work out its exact position in reference to the world, this allows the QR X350 PRO to hover in a stabilized position hold mode. With a simple one switch flip or loss of signal the QR X350 PRO will fly itself back to its take-off position and land! Additionally, it offers a manual mode for the sport flyer and even an onboard low voltage warning system to alert you when it’s time to land.
This version of the QR X350 PRO comes completely ready to fly including the high quality, fully programmable DEVO 10 transmitter (with extended antenna providing 2KM control range), 3S 5200mAh LiPoly flight battery and balance charger. Also included is the all new G-2D brushless camera gimbal which is designed for use with Walkera's iLook HD FPV camera and also the GoPro Hero 3. The G-2D is pre-tuned from the factory requiring no setup, simply bolt on to the bottom of the QR X350 PRO, install your iLook or GoPro Hero 3 camera and you're ready to shoot professional stabilized aerial video!
• Completely Ready to Fly
• High capacity 3S 5200mAh LiPoly battery provides 25 minute flight times
• Improved precision flight control system
• Enhanced GPS position holding
• Altitude sensor
• Compass sensor
• G-2D brushless camera gimbal (compatible with iLook and GoPro Hero 3)
• One Key "Return to Home"
• Stable mode with GPS and altitude hold
• Failsafe to return home & landing
• Low voltage protection
• Devention DEVO 10 programmable transmitter with 2KM control range (mode 2)
• Balance charger with world compatible wall adapter
• Easy to see LEDs
Main Rotor Diameter: 556mm
Main Rotor Blade Length: 206mm
Brushless Motor: WK-WS-28-008A
Brushless ESC: WST-15A(G/R)
Main Controller: DEVO-M
Transmitter: DEVO 10
Battery: 3S 11.1V 5200mAh LiPoly
Flight Time: 25 minutes
Brushless Gimbal Support: G-2D (Compatible with iLook and GoPro Hero 3)
Walkera QR X350 PRO Ready to Fly Quadcopter
G-2D brushless camera gimbal
DEVO 10 Transmitter (Mode 2 - left stick throttle)
QR X350 PRO 11.1V 3S 5200mAh LiPoly battery
Balance Charger with world power plug adapters EU,UK,US, AUS
8 x AA batteries for transmitter
*Note: The QR X350 PRO uses 3.5mm bullet connectors for the battery plug. An XT60 adapter is available, please see related items below.
Unit Weight (g)
Max Charge Rate(C):
I have had this quad for a month now and really happy with the purchase. It handles excellent even loaded down FPV gear. Return to home and GPS hold worked perfect right out of the box with the simple compass calibration. Shipping was only 2 days to Canada, and box was packaged really good. I would recommend this Quad to anyone with some RC flying experience.
https://youtu.be/7brU-OXj4DAOk, so finally had a few flights on it. The stability is quite good, not as good as a DJI Phantom 2 a fellow club member has, but not bad. In fact quite good. Not too much wonder when in GPS hold mode.
I personally prefer to fly it in altitude hold/balance mode as it is much more manoeuvrable, especially with the rates turned up to 130pcnt. Then the copter will shift. In GPS mode, the rates don't seem to have any effect and it is very sluggish.
I have not tried the return to home yet.
If I was looking for another one then I would not get the Devo 10 radio as it is nothing special really.
The camera gimbal is good, but a bit strange in set-up. The picture from a GoPro is good with almost no jellow effect and very stable.
So overall, a good option for this type of quad, but get a simpler version and use your own radio.
Ok, this is more of an unboxing/assembly review, I will be flying it later and post that review when I have.
The box - arrived quickly even with the free shipping, but only single boxed. There was waterproofed paper around the box, but take that off and you are straight to the printed Walkera box. One corner was damaged but fortunately the contents are fine as they are in a thick vacuum formed plastic container.
VERY IMPORTANT - first thing I did was to charge the 5200mAh battery using my normal charger. BUT the male and female 3.5mm bullet connectors from the battery are REVERSED compared to every other LiPo I have ever bought, so be careful connecting not to reverse the polarity. I did not use the included charger as it only outputs 0.8A and so for a 5.2AH battery could take up to 7 hours to charge! So a pointless charger.
Mounting the camera gimbal - you have to put the black cruciform metal part on the bottom of the quad first (the easy bit) and then fiddle around to get the 2 small screws through all the gimbal with a small allen key to attach the gimbal base to this metal cruciform. Not easy, especially if you have the shakes! Got it done eventually but seemed harder than it needed to be.
It's now ready to fly, so will hopefully get out later and report back findings.