2.4GHz receiver for Assan X8 systems.
Compatible with all X8 transmitters.
Size: 36 X 14 X 3mm (1.97 X 1.02 X 0.39 inch)
-Highly secure and robust link
-No crystals or channels needed
-No interferance from motors, ignitions or metal to metal friction.
-No need to change any settings on your radio.
-Works with all X8 systems.
tres bon qualite recepteurHave used many of both the larger hard case RXs and smaller heat shrink RXs for several years now with Futaba and Hi-Tec TXs with hack modules and plug in and am mostly satisfied with performance.
Heres the snag could not find a plug to suit micro RX, infact ruined mine
trying to fit the wrong spacing.
Can anyone tell me if the 1.7 or 1.9gm HK servos will plug in?good flight range,
easy to use
dont forget to order at the same time the mini jst plug
Assan is a good receiverDoes somebody know, what is a operating voltage of this reciver? Its, normall 5-6V or, only single lipo cell 3,7V (1S)
X8 R4 4Ch 2.4GHz Receiver (Mini JST plug) great little receiver but watch the voltage you put in to it i burnt 1 out on 4 volts.
Works great on 3 volt system's gregTrs bonne qualit de recepteur micro.
seul ombre au tableau les pins mini JST plug sont inverses par rapportau standart lextrieur - au milieu.Every good Receiver, have 4 and will order more. Have use in extra light wieght indoor by removing cover and plugs, solder direct onto board.Empfnger ist Klasse mit einer super tollen Reichweite, nicht nur fuer den Indoor-Bereich zu gebrauchen.
Hab diesen Empfaenger schon sehr erfolgreich in einigen Zagis eingesetzt.Here is more about the two slightly different connectors that drive everyone crazy as the manufacturers decided to be different from each other:
The 2.5g Blue Arrow servos are setup to plug into the Futaba 6004FFM micro JST receiver. Futaba used the ~+- pinouts and also used the slightly smaller 1.25mm Molex connector. You'll have to fabricate a 1.25mm to 1.27mm adapter cable or put on new connectors instead. There are several sources for the connectors, either one.