A perfect receiver size battery to replace those warn out old fashioned NiCD and NiMh receiver packs. Although only 700mAh LiFePo4 batteries have a superior useable voltage range when compared with NiXX batteries.
This pack will work with most receivers on the market without the need for a UBEC*
Voltage: 2S1P / 2 Cell / 6.6V
Discharge: 5C Constant / 10C Burst
Weight: 41g (including wire, plug & case)
Dimensions: 53mm x 30mm x 15mm
Balance Plug: JST-XH
Discharge Plug: Standard JR Servo plug
* Always check the suggested input voltage of your receiver before using LiFePo4 batteries.
Unit Weight (g)
Max Charge Rate(C):
Tiny battery that puts out plenty of current. Tested to 6amps, though I wouldn't want to pull that current continuously. I have one in a plane running three Hitec HS 5085MG servos and each flight only pulls 38mAh from the battery (granted very short flights, 1:30.) I try to use these when I can fit them in the plane instead of an external BEC because I perceive them as being slightly more reliable (not that I've had trouble with Castle external BECs.) As usual, Zippy batteries are tops and this one is no different. I use these for my 6V servos (Hitec says they're fine for 6V servos) without a regulator.great for repair my driller machine i used 3 pack in serial for do 18 volts and it's cost me 10 $ less expensive than buy a new pack ni-cd, don't forget to put a lipo buzzer for not over drain the battery now my driller is super powerful and destroy the metal of drill. super pour reparer une perceuse de 18 volts en ni-cd , j'ai utilisé 3 pack en serie , tres bonne puissance la perceuse ne faiblit pas ! c'est les embout de ma perceuse qui se detruise sous la puissance de la lifepo4 . perfectGreat little battery to power servo and RX, 6 volt servo's will have no trouble with these and you can save the weight of a switch and or a regulator.This battery has plugs. It works....Hallo; a great cell for transmitters they use four 1.5V NIMH batterys. I have two and they works great for many years.Nice small receiver pack. I use it for both powering my brushless esc program cards and as a receiver pack in my 1cell pan cars.Great for my needs, and great priceI brought two of these batteries for a nitro car I have. The capacity is great to handle two high torque servos. I used the both of them in parallel. That equaled over an hour of run time. Plus, when put side by side it is the closest size to the original AA holder that was used in the receiver box.Good quality, lots of bang for your buck.
It fits where I want it to fit and powers what I want it to power.Hard to argue at the price. Very light and deliver a monster punch for its size - enough to make the Leopard 4074 in my Pursuit Mono hull turn the prop shaft and I measured it at 9A for about 5 seconds. This just just what you want in a receiver pack as long as it can handle the voltage. I recharge after a mornings racing. Mine are not well balanced with 1 cell taking an age to come up to voltage.
Given the price its probably wise to get the next size up in a boat as there is precious little disadvantage weight wise with a boat.