Polímero ABF 1000mAh 3S1P 20C litio

• Overall
• Quality
• Value

ABF 1000MAH Lipo

Nov 14, 2007

I bought two of these to use in my T-34 and Thunder Tiger Zero. I get the same flight times with these as I do my 1100 that came with my T-34 (bought here) and better than the Dualsky 1050 MAH battery (over $35 USD) which is larger and heavier. For the money these are my battery of choice. Ten minute flights are common and I use a balance charger bought here the simple Hextronick. Batteries come down warm but not hot I fly at full throttle for most flights.

I am pleased with these batteries!! Thanks

• Overall
• Quality
• Value

Nov 14, 2007

, . 920, 900. 20.

• Overall
• Quality
• Value

ABF 1000Ah 3S1P

Nov 14, 2007

great battery, right size,weight, power. 3D my CHARGER just right!

• Overall
• Quality
• Value

Nice battery for TX

Nov 14, 2007

I have bought one of these batteries. On the cycler, it gives only 860mAh.

But the price and (mostly) the size makes it worth.

It fits perfectly on my futaba 7C transmitter, so it can replace battery on all TXs whitch uses tower batteries.

• Overall
• Quality
• Value

abf 1000 3s

Nov 14, 2007

I bought 2 of these, and are powering my honeybee "mothed" helis great! On par with the CSRC 1250 batteries I am also using. The wires are thin, but are working for my amp draw!

No sign of swelling, consistently discharge to the same voltage, stay in balance pretty well!

Will buy more if I need them.

• Overall
• Quality
• Value

100 mah batter

Nov 14, 2007

I ordered 4 of these in June, have charged and recharged and find this battery to be excellent for my scratch built foamies weighing 12-16oz both 1000 and 1900 kv brushless motors with a run time from 10-15 min depending on throttle control. Bottom is foam protected for your "accidental minor crashes".

• Overall
• Quality
• Value

battery

Nov 14, 2007

I bought 4 this pack for my RC-Factory Flash 3D. Weight 74 grams are very good, but cables are very thin - only 1 mm :(

• Overall
• Quality
• Value

ABF 1000 3S1P - Low C rating

Nov 14, 2007

I bought this battery for use in my 3D depron Extra 300. However I was disappointed to discover that it had no where near the 20C rating. I'm getting low voltage cutoff at only 13amps.

Perhaps a hint is the thin battery wire attached compared with the 1300.