Unidad EDF conductos del ventilador 6Blade 70 mm 2.75inchCuchilla Diámetro: 68.3mm / 2.68inch
Diámetro exterior de la caja: 73 mm
Espesor de la pared: 1.53mm
EDF Longitud: 59 mm
Frente Sábana Diámetro: 83 mm
Los agujeros de montaje del motor: (de 18 mm y 22 mm)
Tipo de hoja: 6
Tamaño del eje: 4 mm
Este EDF tendrá un motor con un diámetro máximo de 28 mm. (Ver artículos relacionados)
Hecho de alta resistencia de plástico reforzado.
SKU (Número de Referencia):
Peso ( g)
- SKU (Número de Referencia):
perfect fin in my vampireLooks like a good unit, however it will not fit the 64mm t-45 as mentioned below without a LOT of sanding to the aircraft to make it fit.solid edf unit, i have used it to replace the unit in my mig 15, the six blade has good whoosh noise at altitude, comes with a prop adapter and spinnergood quality and well balanced edfsuper price they come with a 4mm shaft
converterGreat for that little money!
Replaced the edf on my Zephyr V70 with this one because original was broken.This was very cheap so I bought one just to see what it's like. The plastic does seem a little thin but could easily be reinforced with a bit of glass cloth and epoxy. I bought the Turnigy 2226-3000 70mm EDF Outrunner to go in it and although it is supposed to be 29mm in diameter, it fits the above edf surprisingly well without any mods at all. The edf comes with a shaft adapter which fits the motor and four screws to hold it in place and everything lines up just fine. I haven't tried it yet as I haven't received the ESC for it.Lots of fun for 4.. I brought this just for the fun of owning an EDF unit to play with but after getting 717g of static thrust with an old inrunner I am half way through building a plane to mount it in. Build quality is not so good, it required some trimming with a blade but it was only 4. you get what you pay for/1Had no problems with it, it is of the correct dimensions, the plastic was not warped and the lip on the front is removable, decreasing the size of the fan.this unit is well okay cheap , and you really need to choose an appropriate edf motor for it , it took me a while to align the blade on this one!