Eles una plataforma atractivo y magníficamente diseñado con aa gran cantidad de interesantes características que hacen de este modelo uno de los mejores en su clase.
Por la dureza y fiabilidad, el modelo cuenta con un fuselaje moldeado por soplado que utiliza nylon y es prácticamente indestructible, las superficies de vuelo están hechos de espuma dura deDesde un punto de vista práctico, las alas son plug-in y el modelo no requiere pegamento para el montaje. Todo simplemente tornillos juntos. El pabellón exterior es puramente para las miradas y se utiliza cuando el se vuela como un planeador, aunque Desajusta en segundos para revelar una plataforma preparada la cámara, con un agujero de montaje de pan / tilt servo que ha sido pre-moldeado. Esta cubierta de cámara de gran plataforma / ala está asegurado por un pestillo de liberación rápida y una vez retirado, revela gran área de copa para las baterías y equipos montaje en una placa de madera contrachapada pre-instalado. Todos los servos, motor y por supuesto, pre-instalado.
El ala de dos piezas tiene molduras para la adición de aletas, si se desea, más moldeada C G de indicadores en la parte inferior de los controles previos al vuelo rápido. No hay duda de que este es un modelo de alta calidadmagníficamente diseñado a un precio excelente. Sería justo decir que es más atractivo a la vista que la mayoría de las plataformas por no hablar de mucho más dura, la dará las horas RC piloto de disfrute durante muchos años por venir!
• Plug and Fly - Apenas añada su elección de la batería, transmisor y el receptor
• Revestimiento de las alas y plástico moldeado por soplado fuselaje
• compartimento fuselaje delantero Amplio
• Canopy / escotilla tiene base plana para el montaje de la cámara FPV
• funcionamiento estable vuelo
• aletas opcionales
• Plataforma de montaje plana de popa del ala para montar la antena FPV
Volar Peso: 950g
Motor: 2812 1400KV
Servo: 9g x 4
4 ~ 5 transmisor y el receptor CH
LiPoly batería 3S 11.1V 2200mAh 1800 ~
SKU (Número de Referencia):
Peso ( g)
- SKU (Número de Referencia):
love this place. solid construction and decent glide capabilities, haven't had it long but so far it's outstanding i did swap out the motor and speedy as well as aileron servo's and elevator servo. and used them for flaps while using mg servo's all round, only because of the distance i want to do with this i dont want any failures.
all in all on the build i'd tell everyone to go buy one.!!!
love it!!!The electronics are crap so I replaced the lot.
The plane itself isnt too bad but and its a big but...
The motor mount and pod are awful.
They are both soft and brittle.
I have ordered the V2 mount from Hobbyking in the hope that I will at last have a good fpv platform.
In the end this has cost me nearly double the buying price to get it working well.
The FPV raptor 1.6 is the best fpv plane i have had. Its rugged and has loads of carrying capacity. Just replace the electronics. They really need to supply a kit version.This is great aircraft. The only thing that lets this aircraft down are the wing bolts, it would be more convenient if it had some type to thumb screws or quick release system.
Has good pay load capacity, and EPO foam is good quality.
Packaging could be better to protect the aircraft, mine had damaged on vertical stabiliser, but nothing a quick soaking in boiling water couldnt straighten out.
The decals I received where like 100 years old, all curled up and they dont stick. Hinges also need some reinforcement but those minor complaints aside, quality wise it seems fine, and a fairly easy build. There is LOTS of room in the fuselage, I shouldnt have problems mounting a flight controller, GPS, OSD, and amp sensor.
I flew the maiden with a 2200mAH battery and no fpv gear besides a mobius in the cockpit. Its borderline tail heavy even in that configuration, pitch stability was bad, didnt fly nicely. Forget about even smaller batteries, with a 2700 and 3300 it balances out and becomes a much nicer plane to fly, however, it also becomes even more underpowered than it was. Its OK for FPV and learning how to fly, but the power just isnt there to get you out of trouble, and even doing a looping from level flight is nearly impossible without diving for speed first.
Lack of power makes take off also a bit of a challenge, it needs a healty throw. Although I did manage to take off from the snow with no problems. Maybe it will work on (wet) grass too.
Power aside, flight characteristics are very good. Glide angle is excellent and I suspect flight times will be impressive (didnt time my flights, and it was freezing cold, but I suspect 20 minutes will be a given). She is pretty forgiving when stalled (if cg is correct), rolls nicely, doesnt 'auto level' like a bixler, but i<a href='http://www.hobbyking.com/hobbycity/store/uploads/684449117X991778X39.JPG' target=_blank>Igor</a>
http://youtu.be/Jksawf6IYucPurchased for my first FPV flying experience and flew well but felt a little under powered. Replaced all my servos for metal geared and fitted 40A ESC and a NTM 28mm 1400kv motor......perfect.
I went a step further and swapped out the wings for 2m Phoenix 2000 wings with minor alterations. Maidened it today and what a great plane for FPV gliding about was perfect. Needs a fair bit of weight in the nose and 2 x 2200mAh 3S batteries are perfect. As it doesn't use much power flight times are great too. HIGHLY RECOMMENDED.....May be a little under powered but this plane can take a beating. Went into a nose dive close to the ground and hit with a load bang. Picked it up and brushed off the dirt to find a little gouge in the nose. I replaced the battery and check the flight controls and I was flying in 5 mins.I can't really recommend this one because it requires so much upgrading to make it good. Mine arrived with 2 dead servos so I replaced most of them. The body is hard plastic, which is nice, but it's also heavy meaning that if you're going to put in a big battery and FPV gear then you also need to upgrade the motor. With stock motor it's ok but slightly underpowered and definitely will NOT take off from the ground as advertised, even with a 2200 in there. I ended up upgrading the motor to a Rimfire .10, which now allows it to take off from the ground and gain altitude reasonably quickly. Of course this also required a new ESC. You can see where this is going... It's now a much more expensive model.Received it the other day double boxed which was good as outer box damaged,Hole in the side inner box was all good, on open the box wings wrapped in bubble wrap no damage, fuselage is bigger than expected blow moulded plastic as is the Phoenix. All bits and pieces are as they should be seems as though there are lots of spare screws 2 spare clevises and there was safety clevises rubber bands. Motor pod fits well and 4 screws to secure and is as described and esc, rudder and elevator fit in plastic clamp which clamps through tail section 2 screws for elevator and 2 screws for rudder all fit good, now for the bonus if you have a Phoenix the wing are exactly the same so the 2 meter wings fit and if you have the 2000 Phoenix you know have the 1600 Phoenix as these wings fit. All in all happy with purchase and HK service. Maiden flight to follow.