Flycolor Raptor-S tower is an outstanding combination of F3 Flight Controller, Power Distribution Board and four 30A speed controllers packaged in a two-tier PCB setup. The intergraded connector between the boards provides for more stable performance. The tower package comes in a lightweight 20 grams and overall dimensions of 41.5 x 36 x 15.1mm making it ideal for drones from 130 to 330mm wheelbase.
The FC comes with a built in OSD providing current and voltage information straight to your screen, making it easier to monitor your flight. Large solder pads are provided on the edge of the lower ESC PCB making it easy to connect up your battery, motors and other peripherals that need power (eg. VTX and FPV camera).
The ESCs use BLHeli-S firmware which is designed for superior performance in multi-rotors and uses hardware generated motor PWM for smooth throttle response and silent operation. Multishot / Oneshot125 / Oneshot42 / DShot150 / DShot300 / DShot600 protocols can be used.
This combo package provides an easy way of setting up your racing drone.
• Two-layer structure
• Integrated 4 in 1 30A ESC, PDB and F3 Flight controller and OSD
• Integrated 5V/1A, 12V/500mA for Image transmitter, camera, buzzer, LED and other peripheral devices
• Integrated Ammeter for OSD
• Compact and lightweight
• Very easy to install with solder tabs on outside
• Compatible RX protocol: PPM, PWM, SBus
• Powerful ESC controller EFM8BB21F16GMCU, pipelined 8-bit C8051 core with 50MHz maximum operating frequency
• Dedicated high-frequency driver, makes the start smoother. ESC maximum speed is limited to 500k eRPM.
• The USB on the FC can also be used to upgrade the ESC software or adjust the ESC settings
• ESC protected from damage
• BLHeli-S firmware for high-performance motors and smooth throttle response and silent operation
• ESC Analog protocol: Multishot / Oneshot125 / Oneshot42
• ESC Digital protocol: DShot150 / DShot300 / DShot600
• Hardware, cables and silicone power wire with XT60 connector
• Suitable for 170-450mm wheelbase multirotor frame kit, especially for X and Monster DIY frame kit
Model: Raptor-S Tower
Flight Controller: F3 Supports PPM, PWM and SBUS
FC integrated: OSD, 5V/1A, 12V/500mA, Built-in current meter
Continuous current: 30A
Peak current: 40A
Lipo cells: 2~4S
Dimensions: 41.5 x 36 x 15.1mm
1 x Raptor-S Tower
8 x M3 nuts
4 x Nylon screws M3 x 12
All connecting cables and power wire with XT60 connector
SKU (Número de Referencia):
Peso ( g)
- SKU (Número de Referencia):