HobbyKing X16 Jet EPO Chuck Planeador

• Overall
• Quality
• Value

Customer Rated

Sep 21, 2016

I got one of these for my kids and we have really enjoyed tossing them around in the basement and outside. Good cheap fun! The only issue is that the nose breaks off easily when it runs into something (which it does/will). It glues back on easy enough, but a little annoying. Overall, I highly recommend it as a fun little toy or even as a scale little model to display as it could be painted/decorated easily.

• Overall
• Quality
• Value

Customer Rated

Jun 20, 2015

Perfekt fr RC-Umrstung geeignet.
Nachdem ich die X18 schon erfoglreich umgebaut hatte war nun die X16 dran.
Mein Setup:
Motor in Pusher-Anordnung, Ansteuerung nur ber Elevons und Delta-Mischer.
- Turnigy 1230 4500kV Inrunner
- 2s 200mAh
- 3x3 GWS Prop.
- 6A Turnigy Plush ESC
- orangeRX Vierkanalempfngerlein
- 2x 2,5gr-Servos

Wenn der Schwerpunkt mal stimmt (bei mir war etwas Ballast vorne ntig) fliegt das Ding wie auf Schienen, absolut hervorragend. Man hat das Gefhl, ein deutlich greres Modell zu steuern. Die Flugleistung ist sehr gut, das Ding kann sehr fix, aber auch gemtlich geflogen werden. Absolut empfehlenswert als RC-Modell.
Nun hab ich mir noch die X22 bestellt, um das Trio voll zu machen ;)

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 13, 2015

schaut gut aus, tragendes Profil, leichte V Form, SWP stimmt und das Teil fliegt ausgezeichnet, nettes Mitbringsel fuer den Nachwuchs

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 04, 2014

this small planes fly really well.....

• Overall
• Quality
• Value

Customer Rated

Oct 29, 2014

This is my RC conversion setup:
10A Speed controller (HKESC10A)
Brushless TG 3800kV motor (T1811-3800)
300mAh LiPo (9210000080)
GWS 3030 propeller (GWS-prop-DD-3030)
2X TG MX-96E digital servo (9045000010-0)
4CH micro RX from orangeRX (old model)
I cutoff the two rear fins and put them on an axe, steered by the servos and used the Deltawing mode in my Spektrum radio. I had to add a lot of DR (40pcnt) and expo, otherwise it is impossible to steer; much too sensible! It is very sensitive for crashes too. You will see that after each crash -(you'll have a lot before knowing how to tune it well!)- you will have to trimm. The EPO foam is for CHUCK gliders, so you can bend the wings and that gives other flightcaracteristics after each hard landing. I suggest buying 2 of them. One to try out and a second one to use as your final model. You just swap the electronics! Finally it flies really great! It has a good sore capability and you can land almost vertically. It goes really fast at full throttle, but be carefull: it is really a small model so you can't go too far away for visibility reasons!
A lot of fun to build and experiment and even more fun to fly. Cheers! Kris

• Overall
• Quality
• Value

Customer Rated

Aug 18, 2014

Test glide proved it to be slightly nose heavy, however reflex to elevator up slightly and it flies really nicely, looking forward to giving it a good throw when the weather settles down.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 18, 2014

I made this as a RC slopeglider:

https://www.youtube.com/watch?v=7U1xWnYrML4

Flying:

https://www.youtube.com/watch?v=1j8D68M_5sI

Flying weight with RC is 40 gram

• Overall
• Quality
• Value

Customer Rated

Aug 12, 2014

Hi !
I converted this little F16 as a PSS slope glider using the smallest servos i had, a 4 channels Orange micro RX and a 160mAh 1S lipo.
AUW : 40 grammes
Maidened yesterday afternoon with 15 to 25 Km/h wind on the slope - EXCELLENT !!!

• Overall
• Quality
• Value

Customer Rated

Aug 05, 2014

Just received Mine today : this Chuck glider fly very very well !

I'm sure it can be converted in a micro PSS glider in a few minutes of work.... ;-p

• Overall
• Quality
• Value

Customer Rated

Jul 13, 2014

here the flying report, flies really good, elevator used as ailerons and elevons. no ailerons at wing needed, roll rate is fast. It flies fast enough for jet feeling and stable for outdoor at light wind conditions. Flying weight with akku and 2 servos is 75g. CG can stay like in gliding version.
In my first review I named wrong akku, I use 2S180, not 2S300, would be to heavy, flying time of 4-5 min is possible with 2S180.