KB20-30-22S 4200kv de motor sin escobillas (FIN)

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 21, 2011

ottimo come motore lo provato sul elicottero tarot 250

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 15, 2011

super petit moteur sur ma moto rc 1/8em avec un esc de 20 amp les vis de fixations sont en 2mm

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 14, 2011

bon produit chauffe rapidement trop petit pour mini inferno

• Overall
• Quality
• Value

Certified Buyer Rated

May 15, 2011

used as a replacement motor on the Turnigy 1/18 Brushless 4WD Stadium Truck as 2mm shaft fit the stock pinion. Mount holes are 16mm apart and the Trucks mount required 17mm. Needed to enlarge the centre hole in the mount to 10mm to accommodate the bearing boss on the motor. 1000kv slower than the stock motor but it ran at insane speeds anyway. Runs cooler so hopefully this one won't burn out like the stock. Good quality finish, cooling fins a nice touch.

• Overall
• Quality
• Value

Customer Rated

Apr 17, 2011

I used this to replace a 370SD brushed motor on a Exceed Eagle 50 (aka Walkera 22e) Replaced the bullet connectors as the ones included did not fit each other as the female where to big! The mounting screws are M2.6 and the frame required minor filing to fit. The hole spacing is slightly narrower
by 1 mm. Paired this up with a Mystery 40A Brushless Speed Controller (MY40ASBEC) and 8T pinion. It was necessary to dial the throttle curve back to keep the rpm's down. You will need a direct drive tail to keep up with this combo. Motor runs cool and has plenty of power for 3D.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 01, 2011

Very good motor. I installed it in my 1/18th truck with little effort. I used the Trackstar 18A esc sold here.

• Overall
• Quality
• Value

Customer Rated

Oct 16, 2010

Awesome little motor. Pack a lot of punch.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 11, 2009

Put this motor in a RC18t with a turnigy 18amp esc and it 'just works.' Fits without modification and pulls around 16amps peak using the stock gearing and a 2 cell lipo. Performance is similar to stock, perhaps a touch faster, but smoother and more controllable. If you want more motor get the higher kv version, otherwise this is a fantastic replacement for the stock setup.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 23, 2009

very good well packed

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 07, 2009

I used this motor in my 1/18th scale BRP SC-18V2M. It did require a plate to fit over the bearring, but this motor has the exact same performance as other much more $$ motors! I would buy this motor again!