Chasis principal (fibra de vidrio) la placa inferior - A2003T y 110BS

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 09, 2016

A lot sturdier than the stock one. Almost no flex and improves handling a lot !

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 27, 2013

plastic main chassis broke after a hard crash, so time to upgrade to this one! seriously doubt this one will be doing any breaking in any crashes, only thing is its troublesome to transfer all the parts over

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 07, 2013

am holding off installing this, as i drive in very dusty/rocky ground and i like the bucket wall protection the factory plastic one offers. (i bought after reading comments about it reducing flex, and saving gears, but just set your slipper clutch correctly and its not an issue)

• Overall
• Quality
• Value

Customer Rated

Aug 12, 2013

Essential once you start upgrading. Adds a heap of strength to the chassis, much easier on the drive train as there is heaps less flex. Only takes a few minutes to fit if you leave the upper strut attached.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 07, 2013

Recommended upgrade. All the spur gear and pinion shaft alignment issues go away once you have a rigid chassis (the original plastic chassis flexes way too much).

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 12, 2013

exelente upgrade para buggy 1/16

• Overall
• Quality
• Value

Customer Rated

Aug 22, 2012

Overall: Good Main Chassis Bottom Plate. I set this on my "1/16 Brushless 4WD Monster Beatle" under stock main chassis.
Pros: Very hard.
Cons: Some holes very nearly the same.
. , .
: .
: , .

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 06, 2012

It's much sturdier than the original plastic bottom plate, however, there are no sides, so dirt and dust sneaks into it easier.