MCPX M0.3 piñón de 1,5 mm 9T
SKU (Número de Referencia):
Peso ( g)
- SKU (Número de Referencia):
pinion need for the 1220 motor for install in the xmods 1/28alles bestens wie gewohnt! thanksworks very good with my hp06v2 (1,5mm shaft).
i glued it with some loctite 609 (the green one) and it fits perfect.
thumbs up !Gut fuer mcpx brushles motor!Hi all i have the same issue, i bought the 14000kv brushless motor for mcpx and the hole is fractionaly to large so it slips on and off. any ideas not sure ca will hold on a smoth surface that well under load.So I tried to put the 1.5mm pinion on this motor and it is too big!!! The specs say 1.5mm!!! W-T-F!ich wrde es hier kaufen befor wo anderst viel teurer gutWorks so far very good and cheaper than in any other place - so what? Thanks HK!This one is very important for MCPX as the brushed motor is not able to generate a lot of of thrust 8T so a 9T is recommended for high head speed as there is a whole lot of pitch to compensate that.