Flotar en su cocina, el pasillo del filo y mostrar sus habilidades harrier a miembros de la familia previamente demasiado perezosos para viajar a la pista de aterrizaje el domingo con usted!
La luz ultra y pequeña Micro 3D Piaget se presenta como un kit y le llevará 1 noche para completar. Se incluye el motor micro y esc. Basta con incluir sus propios servos Rx y 2,5 g.
Hecho de espuma EPP mástiles de fibra de carbono y duraderos, este pequeño kit será recuperando para más castigo cada vez!
Presupuesto:Longitud: 472mm (18.6in)Envergadura: 418mm (16.5)Peso del vuelo: 45 ~ 53 g (con batería)Motor: C05 3700kv sin escobillas outrunnerESC: 7AmpObjeto: GWS EP5030Servo: 3x2.5g (no incluido)
Necesario:Su propia TX y RX~ 100 ~ 200mAh 1 2S 20C Lipo3 x 2,5 g servo
SKU (Número de Referencia):
Capacidad ( mAh )
Peso ( g)
- SKU (Número de Referencia):
Great little plane, just make sure you don't build it to heavyNice little indoor flyer , nothing for outside ,to light.
The kit build simple and fast .
The landing gear is to light,need's thicker fiber rod.The lighter you build the better it fly's .
Save on wire and plugs,solder directly and safe lots of wight ,cut the servo cable to length every gr you can safe the better it fly's.
Safe on shrinking tube not more than
strictly needed .
Safe wight is the magic word .Way too $ expensive for what you get with it.
Interesting, I see that you have to write a long review!!!!!!!!!!!
Compre, 'short & sweet'
This plane is not good. Very slimy, the motor becomes to hot after 1 minute of hovering. Landing gear is broken after 2 fly.Weak plane, be strengthened, the standard motor very fairWow easy to fly,I thought it was going to be to quick twitchy! But it fly,s slow almost hovering on my first go! it was a bit fiddly to build ( being small) but strait forward the only mods I made were to build up the motor mount area with a little extra Epp and run 2x1mm carbon rods under the full length of the horizontal fuselage also the length of the ailerons trailing edge much More responsive its a great little plane!!!!!!!!!!!After flying an array of expensive planes and helis this i've have more fun. What a ton of fun for a mere 40 buck plus a few bits.
Good job HKI finally completed my Stock Piaget with the standard motor 8x3" prop and 8 Amp Mag ESC, I waited for dead cam day and took it for a test fly. Everything was going fine until I opened the throttle only a bit over half and the ailerons started to shake up and down violently - (I didn't have the airbrakes on either) I used the platic hinges that came with plane and placed the where the manual said.
The result was a rather bad forced landing as theI have now had about 50 flights on my plane. It has been crashed a fair bit flying in a small space, I am amazed at how well it still flies with all the repairs ! It flies really well and even hovers with ease.The only issue is that it is very flimsy foam so the flexing effect the fling during hard turns or rolls. Other than that it has been a blast.Super little plane. Used 2.5g servos,hyperion 120mah 2s 25c pack,Ar6300RX, all up weight 55grams. Flimsy foam, reinforced a little with blenderm..flies well, hovers well. Good power. Thanks HK !