Objetivo aviones no tripulados de fibra de vidrio Plataforma FPV 1520mm (ARF)

• Overall
• Quality
• Value

Customer Rated

Oct 23, 2012

The plane flies very well, if you set the correct CG. (250mm from the rear edge) The downside - very heavy landing gear. Buy the right carbon 120mm height. Fold back the front landing gear, otherwise it will tear off landing))) Good luck!

• Overall
• Quality
• Value

Customer Rated

Oct 03, 2012

Its very small and looks crap. I dont know how you fly this thing. You can probably build something like this at home.

• Overall
• Quality
• Value

Customer Rated

Sep 11, 2012

Target Drone flies :-). And its very fast. Quality is good, but neet to be sreghten Nose Wheel. Hers My maiden flight video - http://www.youtube.com/watch?v=DsXqzUnCIgg&list=UUgu1IJ5NXcCydNS76izSDDw&index=1&feature=plcp

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 06, 2012

The target drone does fly it does require quite a bit of work to get it into the air with setting of wing incidence twisting of the wings and recalculating the CG. With the wing design it flies quite fast. I have been working on this now on and off for two weeks and will have another test fly this week-end. What is needed is at least another Target drone to optomize the the wing incidence and CG settings so that I can have confidence in the final setup. For those wanting to experiment the starting point is as follows: wing incidence 2 degrees positive at root - wing twisting to Zero degrees at tip, CG 125 - 128mm behind leading edge at root.



Good Luck

• Overall
• Quality
• Value

Customer Rated

Aug 29, 2012

The good: Quality and Value exceptional - Mine arrived well packaged with no damage, the plane went together well, and apart from a bit of mucking around on the nose wheel it was really good. I beefed up the nosewheel and the fiberglass around the wing mounting and glued the wings in. Was planning on mounting the motor internally however there wasnt enough room to play with installing it. Installed recommended motor, 45A ESC and micro servos as well as FPV pan/tilt camera setup and tx.
The Bad: 3 failed attempts at maidening this plane, have tried the middle of the recommended C of G as well as both extremes and every time it lunged vertically on take off, stalled, and then fell on its back.

If this plane flew and was stable it would be a solid 5/5 but until that time it is completely unflyable. Hopefully someone gets this sorted and can report on the right C of G, until then mine will be gathering dust which is a shame for such a nice looking model.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 27, 2012

Really catch looking model, but not for beginners. Would be nice to have the front wheel hole pre-drilled. Wings have to be glued on.

• Overall
• Quality
• Value

Customer Rated

Aug 23, 2012

not bad but a little week in the front and the wheal will fold on landing . , all out ,difficult to use as a reliable FPV ,and is not a slow plane.,

• Overall
• Quality
• Value

Customer Rated

Aug 16, 2012

Received mine in good condition.
No instruction on where the CG should be.
Based on CG calculator about 188mm from front leading edge.
Nose heavy with 2200 3S lipo.
Ready to maiden, but i think I will need the flight stabilizer to maiden it.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 14, 2012

This is just a manufacturing and packaging review... I still have to fly it.



1 stars, both wings have the tip bumped and there is also some bump here and there in the top surface.



One wing has the hole for the carbon rod closed by excessive glue usage (I will have to drill it hoping that there is not glue also deep inside the hole where my drill can't arrive).



The place for carbon tube inside the fuselage is not aligned with the fuselage and the right is lower than left and anyway it's also too large for the carbon rod, there is a lot of play. wings won't be solid with the fuselage.



There are no air scoops for motor/esc ventilation.



Will post more once the airplane is ready and maiden.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 14, 2012

buen producto, plusplusplusplusplus