Turnigy 2815 3500KV EDF Outrunner de 55 / 64mmEspecificaciones:KV-3500Dimensiones: 51 x 28 mmEje: 2,3 / 3,0 mmVoltaje: 11.1VPeso: 74gCorriente sin carga: 1.9ARPM sin carga: 38460Corriente de carga: 17.8ACargar RPM: 32780Empuje: 485gMontaje del círculo de agujeros: 18 mm
MTG. Hoyo número y tamaño: 4 x M2,5Incluye 2 ejes, 2,3 y 3,0 mm
SKU (Número de Referencia):
Peso ( g)
Kv (rpm / v)
Corrientes max (A)
Potencia ( W ):
B Longitud ( mm ):
Puede longitud D ( mm )
Max Voltaje ( V )
Un eje ( mm ):
Unit Weight (g):
C Diámetro ( mm )
Longitud Total E ( mm )
Resistencia ( MH ):
- SKU (Número de Referencia):
I have a put a post in the forum with stats for this motor a few of its brothers and sisters but ill put them here too. Motor is good quality and I think will run on 4S fine if kept under 500W.
3S 64mm 5 Blade Fan 19A, 220W, 11.7v 450g thrust (in plane)
4S 64mm 5 Blade Fan 30A, 450W, 11.7v 640g thrust (in plane)
3S 64mm 6 Blade Fan 19A, 216W, 11.45v 480g thrust (in plane)
4S 64mm 6 Blade Fan 29.5A, 430W, 14.8v 640g thrust (in plane)I bought 2 of these for a GWS-262. I use 2 25A tower pro ESCs and a turnigy 2200mah lipo. Its too much for the lipo, it gets hot and puffed out. I'll try a 2600 mah next. Great motors, lots of power. Great value.Looks are good, some flaws.
I had to rebalance both of my motors, I needed lots of CA to balance them but after balancing they ran fine.
Axles supplied with motors were 2.3mm , 3mm and 3.3mm , but 3.3 mm will not fit because the hole is already almost too tight for 3mm axle!
I had to use brute force and hammer to get 3mm axle of and install 2.3mm.
Real life performance will tell more.Motor appears to be of good quality. On a GWS 64mm, 6-blade fan, Hyperion 3S 2500mAh 25C, Phoenix 25A ESC-low timing, I was pulling 22 amps and 239 watts at 11 volts WOT. Sorry no thrust data, but holding the unit in my hand produced impressive thrust for a 64mm fan. The website says 17.8 amps as 'load current'. If I understand that to mean max continuous, than a five blade fan may be better. No thrust data, but impressive for 64mm unit.Awesome motor, 540W on peak with a 5*5 prop and a 3S 1600 35C hyperion.