Turnigy Aerodrive SK3 - 3530-1460kv sin escobillas del motor Outrunner

• Overall
• Quality
• Value

OK

Nov 12, 2021

Tres puissant, monté dans un bateau avec hélice 35mm.

• Overall
• Quality
• Value

Shaft position doesn't match the picture!

Apr 13, 2020

Motor shaft arrived in different position as in picture. Long part was in the rotating part of the motor. Screws that holds the shaft were glued so it was impossible to unscrew them and reposition the shaft. Therefore I don't recommend this motor if you intended to use it with the long end of the shaft on the fix (no rotating) part of the motor.

• Overall
• Quality
• Value

Great Motor

Dec 29, 2016

Great motor runs on my FT-Spear with 2.2 40C 3S AWG 818g and it goes vertical with 9x6 GemFan 9x6 prop pulls 33,8 amps. My question is this motor 4S compatible ?

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 03, 2016

Good motor for the price.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 14, 2014

Smooth running, good quality.

Testet 8x5 sport Propeller. Unless it is an "E" Proppel or a bigger one a 8x5 is too small. In Comparison with motor size and amp capabilities

• Overall
• Quality
• Value

Customer Rated

Sep 02, 2014

Motor has terrible vibration and it is unusable. Even with no propeller it makes strange noises. Bearings or shaft is bad. I will need to buy some other more quality motor...

• Overall
• Quality
• Value

Customer Rated

Mar 22, 2014

Flies in my Cosmic Wind<br>

On 3S1P 2200mAh<BR>
With an APC 8x6E prop - 384W at 34A<br>
With an APC 8x8E prop - 430W at 43A<br>
<br>
On 4S1P 2200mAh<br>
With an APC 8x6E prop - 599W at 41A<br>

• Overall
• Quality
• Value

Customer Rated

Jan 31, 2014

Very nice motor and I highly recommend these as a very good value. Nice accessory pack with prop adapters for front or rear mount and nice mount. 378Watt; 36 amps with 2200mAh 30C Lipo and 9x4 APC (genuine not copy) prop. cruise (50pcnt throttle over five minutes) I get about 135W or - a 10 inch prop beyond the safe limit, but in reality the RPMs are likely well below theoretical, unfortunately I don't have good enough lighting to get a reliable reading from my prop Tacho. Powers my 820g AUW 1000mm wingspan scratch build Spitfire perfectly, great power at cruise, and unlimited vertical at less than 3/4 throttle. Handled a straight in WOT crash on first scratch build without a scratch... loads of mud cleaned out with HOT water jet, WD40 soak, and machine oil lube ... makes a bit of bearing noise now but runs great ... two dozen flights since and going great!

• Overall
• Quality
• Value

Customer Rated

Jan 15, 2013

Current draw with a 8x3.8 prop = 34 amps (peak). Seems to be the recommended prop for this motor. Haven't checked the flight performance yet.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 10, 2012

Ein Qualitativ hochstehender Antrieb. Sehr schn verarbeitet, smliches bentigtes Zubehr inklusive. Sehr gut verpackt, verwende ihn in einem You can Fly von Hype, zusammen mit dem 40A BlueSeries Brushless Speed Controler als Ersatz fr die abgebrannte Originalausrstung.