Turnigy TGY-50700M de perfil bajo alto esfuerzo de torsión mecánica de retracción Servo

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 17, 2014

Great for landing gears

• Overall
• Quality
• Value

Customer Rated

Feb 03, 2014

I put this servo on mechanical retracts 60 size plane striped the plastic splines within three operations, so don't put any pressure on them '7kg don't think so'

• Overall
• Quality
• Value

Customer Rated

Oct 26, 2013

Bought this for my FPV antenna tracker. Supplied dimensions are correct. Height with arm attached is 31mm. This is a proportional servo, not a "bang-bang" type. The most I could get from it is about 170 degree sweep using a servo tester (it would hit an internal stop at one end, so be sure to check for binding when setting up). Speed is about 1.75 sec from end to end, and it slows as it approaches the set position. It has a pair of yellow metal bushes on the output shaft, which can be swapped-out for bearings if you have a suitable donor servo - I used the bearings from a Hextronic HX5010. Has plenty of torque and my sample runs quite smooth.

• Overall
• Quality
• Value

Customer Rated

May 06, 2013

best servo for pan-tilt fpv:
- low speed perfect reduce jitter from hedtracker
- strenght
- low profile
- high torque
this product must be in FPV section!