Turnigy ™ TGY-S4405S con doble cojinete de 4,4 kg DS Servo / 0.10sec / 39g

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 05, 2014

Vraiment du. Les caractristiques annoncer ne sont absolument pas bonne. Un futaba 3001 ou 3003 est largement suprieur. Malheureusement je ne l'utilise que pour les gaz maintenant. Il faut avouer que pour le prix je ne devait pas m'attendre a une qualit au top

• Overall
• Quality
• Value

Customer Rated

Aug 31, 2014

Oops! Put my review in the discussion board by mistake. Here's my review:
Bought two of these just to see if they were usable in cheaper planes that I'm not quite so precious about. Answer: No. Both servos just jitter around and move very erratically. Appalling rubbish. The Tower Pro SG5010 is still the best really cheap servo I've come across.

• Overall
• Quality
• Value

Customer Rated

Aug 04, 2014

Absolute rubbish servos, I bought 7 of these and right from the start 5 of them were juddery and non centreing. I can't put them in my model plane, It will crash on the first flight. What a waste of money, I'm bitterly dissappointed. I'd give a zero rating on my review if it was possible.

• Overall
• Quality
• Value

Customer Rated

Jun 28, 2014

Bought 4 of these servos and 3 of them are glitching so bad they are unusable, the are so erratic and will not stay still, fit one of my old servos and it works perfectly - so these servos are unstable

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 05, 2013

il va super bien avec mon gyro tres bonne calit

• Overall
• Quality
• Value

Customer Rated

Jul 29, 2013

I put two of these servos in a Firenza but had to take them out. They are very slow to centre and therefore would not be fliable. Also very loud electrical noise, draw 0.5a at rest and greater than 1a under load. very disappointed replaced them with analogue standard servos which work fine in the same conditions

• Overall
• Quality
• Value

Customer Rated

Jul 11, 2013

These servos works smooth, good centering, but the main gear, on the ball bearing get a little loose in a few time; for 8$ these servos are not so bad.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 07, 2013

Quite good servo, since it's standard servo. Good for spare part.

• Overall
• Quality
• Value

Certified Buyer Rated

May 25, 2013

Excellent quality, but as stated before on 5volts they tend to be abit noisy. But besides that they are great!

• Overall
• Quality
• Value

Customer Rated

Apr 06, 2013

servocomandi inaffidabili appena accesi 1 a preso fuoco e 5 vibrano
in poche parole totale 6 servocomadi sono da buttare via