Agua camisa de refrigeración del motor B4563 - Super Versión y trituradora contra sobretensiones

• Overall
• Quality
• Value

Customer Rated

Oct 23, 2011

I got this part ! I would like to mount it on PRODUCT ID: KB45-10L .
For me it is very disappointing :
The diameter inside it`s a lot more than 45 mm.
No seal contains. So you have to glue it to your engine.
The hose connectors are much smaller than the thread in the jacket. So you can`t screw them in !

• Overall
• Quality
• Value

Customer Rated

May 19, 2011

J'ai reu le mme article sans joints toriques, il n'y a pas de rainure usine dans le mtal pour les tenir. WTF? Je suis perplexe comment retenir l'eau " avec du silicone " comme a cela fait un montage propre !!

• Overall
• Quality
• Value

Customer Rated

Dec 29, 2010

now occurred to me after looking at the picture, it may be that mass-produced rc boats stuck on the motor pad/glue/stuck whit some white silicone adhesive paste or glue and this paste is not as a replacement whit cooling jacket. I think that such a silicone paste or glue can get elsewhere. Thus, if it is not designed for o-rings.But inside the shell seems to me very rough for the o-rings installed.and the sloping edge is smooth - accurate to the application of the adhesive silicone paste.

• Overall
• Quality
• Value

Customer Rated

Dec 29, 2010

Jacket not necessarily bad, but the instalation O-rings is other. According to the shape of the edge of the jacket was first pushed onto the motor and then be given on-rings. There's probably pressed some hoops to not damage the o-rings. In this procedure does not require installing o-rings in milled grooves.

• Overall
• Quality
• Value

Customer Rated

Dec 29, 2010

I received this item without o-rings. Also there is no groove machined into the metal to hold them. WTF? Anyone got any ideas? I'm baffled.