X-UAV Lotus Quad -Copter con capacidad de aterrizaje de agua (450mm)

• Overall
• Quality
• Value

Customer Rated

Nov 03, 2014

This is by far NOT for the inexperienced builder. Space, or lack thereof is THE main issue of the build. One would need to be prudent about the physical size of ESC used the length of motor cables and battery size. I had to remove & replace the plywood base tray 3 times in order to get it right. I am using a servo-op cam for tilt and whiles there ample room below the lower dome for such a mod, above it is a whole other story. One needs to measure your motor cables accurately as bundling up wires wont work. Use a pwr dist board to help save space, I mounted mine to the ply base and used nylon spacers to mount a CF board which acted as a sandwich where between the ESC sit. I then mounted my NAZA/PMU/4S LiPo on that. TIGHT FIT ! FPV Tx sits outside on frame pwr by dist board. Using Multistar 4000 4S Green LiPo I get 9 minutes swinging 0945 3 blade props on DIY Drone blue motors. Great flying machine in configuration REALLY HAPPY as its a tough little Quad too, Many intentional crashes and almost no serious damage only foam cracked on rotor guard once but poly skeleton is super tough ! Buy Build & Fly...Ps AUFW=1650g

• Overall
• Quality
• Value

Customer Rated

Oct 09, 2014

Sto installando 4 T motor 2216 con eliche apc da 10" riscontrando che queste sono a rischio, ruotano a filo supporto, anche volendo montare eliche pi piccole, il problema non si risolve perch esse flettono rischiando di impattare con il supporto motore a 4 punti di fissaggio.
Deluso lo sconsiglio, spero che modifichino tale problema che rende il frame impossibile da utilizzare.