montage arbre 8mm pour TowerPro & moteur 24g

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 26, 2013

fit nicely for mushroom type motor

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 21, 2013

Not 8mm, this is a 10mm (maybe 9mm) shaft mount.

• Overall
• Quality
• Value

Customer Rated

Dec 18, 2012

It's not much to look at but it's an extremely handy little mount which is easy to install and makes it easy to remove the motor should you have to. Gives a firm and solid anchor to motor and with a dab of Loctite on the grubb screws virtually impossible to vibrate loose. One less thing to worry about.

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 18, 2012

very light weight, feels a little bit cheap.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 26, 2012

BOUGHT IT AS ACCESSORY MAY USE IT LATER

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 11, 2012

Trs bon matriel - Semble trs solide.

• Overall
• Quality
• Value

Customer Rated

Jun 24, 2012

Lightweight. It fits on 10mm shaft diameter and 8mm. Inside the hole a small portion is 11mm diameter.

• Overall
• Quality
• Value

Customer Rated

Jun 02, 2012

These are great motor mounts for the 22xx motors sold here. Also used other no name bell motors pulled from other RTF and even EDF motors. soft aluminum is easy to drill/file/sand to size. On my scratch builds I use the supplied holes on the mount, just make sure to keep the grubscrews 180* to vertical as to know where to pop the allenkey through to remove motor. A Hobbyking

• Overall
• Quality
• Value

Certified Buyer Rated

May 15, 2012

Gzel ve kaliteli bir rn tavsiye ederim. Benim kullanm amacm farkl olsa da malzemesi iyi...

• Overall
• Quality
• Value

Certified Buyer Rated

May 03, 2012

good mount better than the stock mount for reasons like mountabilty, you can stick the mount with hot glue for better hold on the model etc. bought a couple