Afro 20A Spec Race 4-en-1 ESC et Contrôleur de vol CC3D

• Overall
• Quality
• Value

Great FC and 4 in 1 ESC

Jan 03, 2018

If you have patience and a steady hand, this can be updated to Cleanflight, iNav or Betaflight by getting it into bootloader mode. This is tricky because there are no marked SBL or 3.3V pads, so I shorted a VDD pin on the STM32F103 to BOOT0 then flashed it. Set to flash on connect, set the ESC switch to ON, use a serial adapter (NOT USB) and nothing else plugged in. I have iNav 1.7.2 running fine.

• Overall
• Quality
• Value

Great product

Dec 05, 2017

Wonderful product, on a diatone blade 150, way too easy to setup. Perfect for beginners, no second thoughts just go ahead and buy.

• Overall
• Quality
• Value

Too easy!

May 16, 2017

Super simple time and space saver! If you are new to quad building, this little unit is probably the easiest way to get in the air. Because of it's unusual size, it doesn't work well with all frames, but it works great in most 200 and up frames.

My only concern is that I have had several Afro ESCs burn up on me, but they weren't the race spec, they were the cheap little 12As. My hopes are high though, it saves time, weight, space, and money.

• Overall
• Quality
• Value

Awesome Board for a minimalist build

Feb 19, 2017

Keeps things tidy, though it does get to be a bit of a squeeze on the smaller frames. Have one on the glass/nylon 250, and one on a Dubai 210. Waterproofed both of them for snow-bank landings and they seem to be doing excellent.

• Overall
• Quality
• Value

Awesome Board for a minimalist build

Feb 19, 2017

Keeps things tidy, though it does get to be a bit of a squeeze on the smaller frames. Have one on the glass/nylon 250, and one on a Dubai 210. Waterproofed both of them for snow-bank landings and they seem to be doing excellent.

• Overall
• Quality
• Value

very good

Jan 16, 2017

this board flies very well , is used a nighthawk 200 frame .

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 20, 2016

Très bonne carte cc3d avec contrôleurs intégrés pour un gain de place sur quadri class 250 tarot TL 250

• Overall
• Quality
• Value

Customer Rated

Sep 14, 2016

First I found this device in my Quanum Outlaw 180. Now I ordered another one for my Nighthawk 200 FPV Racer. I must say, this is a very fine board! Especially within the small Quads it is very welcome to forget about a lot of wiring. It saves a lot of space, and fits perfectly to the Nighthawk 200 and 250. I cannot find any negative point - I love it

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 04, 2016

works great, runs openpilot or librepilot, currently running a qav180 frame with 2204 2300kv motors and a basic 6 ch RX and it works great, havent tested the esc flashing ports yet but i havent had to so i'll save that for later, i have got it wet yet and it could be a challenge to water proof but it seems to be do-able.