Corona 919MG Metal Gear Servo 1,7 kg / 0.06sec / 12.5g
Tension de fonctionnement: 4.8V / 6.0V
Courant de fonctionnement: 200mA / 240mA
Vitesse de fonctionnement: 0.07sec.60º / 0.06sec.60º
Stall Couple: 1.5kg.cm /1.7kg.cm
Taille: 22.5X11.5X24.6mm (0,88 "x0.45" x0.96 ")
Poids: 12.5gBande morte: ≤3uSec
Voyage de fonctionnement: 40º / une impulsion latérale 400US voyage
Potentiomètre: 2 glisseur / Direct Drive
Roulement à billes: MR85
Boîte de vitesses: Métal
Fil de connecteur: 215mm
Température de fonctionnement: -20J + 60J
Unit Weight (g)
Couple ( kg ) ( min . 0,01 kg )
Vitesse ( Sec / 60deg ):
B ( mm )
C ( mm )
E ( mm ):
F ( mm)
Perfect Servo for faster small aircraft. Good centering, high precision and reliable. Recommended product.I found the servo to constantly chatter without any load and the dead zone in middle setting was large enough to cause about a 4mm movement in my elevator.
I cant think of any purpose for this servo sorry.one of the best servo´s i know.Great little servo for 3D plane. fast reaction and not at all twitchy. they find centre great and are nice and strong on big control surfaces. I'll be putting 2 more in my plane to complete the plane with all these servos.Doing exactly what they should in my DH-88I use these and other Corona digi BB MG servos in my slopers, especially my combat machines. Great value, very reliable and work as advertised. I give all my MG servos a lube job with Teflon based grease which makes then extra smooth and quit.
I read where people question that they're advertised as metal geared, but find one plastic gear present. The reason for that is that the teeth can get bent, jam the servo, overload the circuit and fry the servo. Hence the sacrificial plastic gear.
Bought one to use on my yaw mechanism for a scratch built tricopter. after the first crash, the servo lost all of its holding torque and made a horrible whining sound (worse than the usual servo whine) but was still usable so i continued flying it. A few crashes later and I could no longer move my yaw mechanism. Took it home, popped it open and found that I had stripped a gear. Did a little research and apparently there is a "sacrificial" plastic gear in amongst those metal one. VERY DISAPPOINTED.I purchased it by seeing the good previous comments. Finally I am a little bit disappointed about the play on the bearings. Two ordered and both impacted. I am using them on a jet of 75cm wing span and both elevons have almost 1mm freedom on each direction. Not very well for fitting a stabilizer...
Other characteristics sound good.Perfecto para mi helicoptero Mini Titan E325 SE, trabaja muy bien con flybarless Tarot ZYX. Es super rapido.
Perfect for my helicopter Mini Titan E325 SE, works very well with flybarless Tarot ZYX. It is super fast.
Highly recommended.un microservo digitale molto veloce