Hobby Roi Servos numérique pourrait coûter plus d'un analogue, mais pour un contrôle précis et largeur minimale morte marque, ils sont un excellent choix.
Balle support portant
Numérique programmable, avec MOSFET lecteur
High Speed & High Torque
Vitesse: .11sec / 60deg @ 4.8v
Stall Couple: 2.2kg.cm @ 4.8v
Permanent Couple: 2.2kg.cm/5deg tenir le coup !!
Vitesse ( Sec / 60deg )
Couple ( kg ) ( min . 0,01 kg )
Unit Weight (g):
B ( mm )
C ( mm )
E ( mm ):
F ( mm)
Got one of these to try.
Works OK. Centres well but really lacks resolution at low speed. It moves in jumping increments so no good where fine accurate movement is required. Will use it for something other than a aircraft control surface. So therefore only 3 crowns.
Brought four of these for a HK 540 Edge EPP plane, found all four have poor centring and bad gear lash (slop)Good servos, I'm using them for my tilt mechanism on my tricopterBin sehr zufrieden. Dienen super Dienste in meiner Calmatogood servo for this priceTorque and speed ok for price but centering is not very good, alot of play / slop, mounting lugs break easily, 1st gear is plastic and ive stripped about 10 of them. Anyone know where i can buy replacement gears?Used these in my Outrage G5 helicopter (450 size) for cyclic servo's. Have run heli several times without any issues. Only problem I found were the plastic lugs on the servo fitting tabs, i had to pack them out to mount the servo flush. I used two spacers front and back of mounting tab, one cut down to fit between the lugs the other as a washer to tighten the mounting bolts.Love these servos they are digital fast, work great at 6v, and the gear-train holds up to most crashes on my CX450BA DFC.
Only complaint is that the case is brittle. So,either strengthen the mount tabs, or buy a couple of the analog 929mg for the case cover and gear-set. Awesome Servo at this price!!The mounting brackets are a bit weak. All four of my Edge's servos are cracked. With some hindsight.. I would stick some epoxy for to fill the underside of the bracket.Just super stuff, bought these for my Thunder Tiger Mini Titan E325s FBL as cyclic. They perform well and are strong. Will buy more of these in the future. Great value for the money.
VCT RC 450 PRO V2 - Mesut AKIN Télécharger maintenant [218kb] Are these really digital? Télécharger maintenant [249kb]