Le moteur de multirotor DYS BE1806-13 est idéal pour les petites et moyennes multirotors et est livré avec des boulons de montage, un adaptateur de prop et 150mm pouvoir conduit avec des connecteurs de balles 2mm.
Rpm / V: 2300kv
Dimensions: 23 × 21mm
Voltage: 3 S ~ 4S (11.1v à 14.8v)
ESC: 10 Ampères à 12 Ampères
Suggestion Prop: 5x3 (3S 11.1v) ~ 6x2 (2S 7.4v)
Trous de montage du moteur: M2 x 12mm / 16mm
Kv ( rpm / v)
Max Currents (A)
Longueur B ( mm ):
Longueur Can D ( mm )
Max Tension (V)
Arbre A ( mm ):
Unit Weight (g):
Diamètre C ( mm )
Longueur totale E ( mm )
Résistance ( mh ):
bought a x6 package of these coupled with 20a ESCs and 6" props.
all came fairly balanced out of the box, after some testing 2 of them died from over-heat.
please note that from my experience they can handle 4s & 4x3 (2/3 blades) props great,
4s & 5x4 or 3s & 6x4 props (2 blades) produce a lot of heat, apparently to the point they stop all together..
3s & 5x4 (3/4 blades) is acceptable but will produce a fair amount of heat.Bought several of these DYS motors and now that I'm making time to do this review noticed they've droped another dollar or two. Great smooth running 1806 motors, motor-mounts. These motors are pretty resiliant too still spin freely after several rough crashes. (To clarify rough I means at minimum prop(s) broke)Very nice little motor, lightweight but has the power needed.
Quality also seems very good.Quality motors for 250 and lower if you are beginner and low on budget. It can give good thrust with 5' props. Have 8 of this motors and only one had issue with windings. Still i give it five stars for quality/price ratio.very good price, no problems with this productGreat little motor for the few flights I've had using them on a ZMR250 clone. Motor is, however, listed here as being 2S-4S capable, but max voltage is shown as 11.1V in the "product config" table. Which is correct ? Are replacement shafts going to be made available ?Very durable motors. Are extremely smooth and are pretty well built.Great little motor. Picked up a set for my 250 quad along with Afro 12 amp optos and 5030 props. Lots of power for the 250 with 3S 1400MAh battery. For this price I will buy more.Bought these Motors for my First quadcopter build. I don't have much RC experience but I love these motors. I run 3s with 12a Afro ESC and with 5030 plastic props it can easily lift my 550g quadcopter with plenty of thrust for those emergency manoeuvres.Used them for my ZMR 250 great Power for the price. And they dont break fast. Crashed very hard sometimes and everything is fine.