EDF Ducted Fan Unit 6Blade 2.75inch 70mmLame Diamètre: 68.3mm / 2.68inch
Diamètre extérieur du boîtier: 73mm
Epaisseur de paroi: 1.53mm
EDF Longueur: 59mm
Avant Suaire Diamètre: 83mm
Support moteur Trous: ( à partir de 18mm et 22mm)
Type de lame: 6
Taille de l' arbre: 4mm
Cette EDF prendra un moteur avec un diamètre maximal de 28mm. (Voir articles connexes)
Fabriqué à partir de haute résistance en plastique renforcé.
perfect fin in my vampireLooks like a good unit, however it will not fit the 64mm t-45 as mentioned below without a LOT of sanding to the aircraft to make it fit.solid edf unit, i have used it to replace the unit in my mig 15, the six blade has good whoosh noise at altitude, comes with a prop adapter and spinnergood quality and well balanced edfsuper price they come with a 4mm shaft
converterGreat for that little money!
Replaced the edf on my Zephyr V70 with this one because original was broken.This was very cheap so I bought one just to see what it's like. The plastic does seem a little thin but could easily be reinforced with a bit of glass cloth and epoxy. I bought the Turnigy 2226-3000 70mm EDF Outrunner to go in it and although it is supposed to be 29mm in diameter, it fits the above edf surprisingly well without any mods at all. The edf comes with a shaft adapter which fits the motor and four screws to hold it in place and everything lines up just fine. I haven't tried it yet as I haven't received the ESC for it.Lots of fun for 4.. I brought this just for the fun of owning an EDF unit to play with but after getting 717g of static thrust with an old inrunner I am half way through building a plane to mount it in. Build quality is not so good, it required some trimming with a blade but it was only 4. you get what you pay for/1Had no problems with it, it is of the correct dimensions, the plastic was not warped and the lip on the front is removable, decreasing the size of the fan.this unit is well okay cheap , and you really need to choose an appropriate edf motor for it , it took me a while to align the blade on this one!