Les chances sont, vous n'attendaient de voir un requin volant tout chalutage autour de votre site web préféré RC et si vous pensez que quelque chose de louche se passe, pensent encore, ceci est une nouvelle version d'un vieux favori maintenant fait de super résistant EPO mousse!
Ce EDF jet d'amusement est facile à assembler, l'unité de ventilateur 64mm, ESC et servos sont pré-installés, la sous-chariot est de brancher, idéal pour ceux qui veulent à la terre du ventre et l'énorme bouche béante permet le ventilateur puissant pour avaler beaucoup de de l'air, ce qui signifie qu'il ya des tonnes de poussée pour un modèle 3s!
Bien que pas strictement «échelle», l'EDF Shark est un superbe interprète, rapide, voltige et des tas de plaisir, il est un plan sportif brillant pour peu d'argent, donc si vous avez envie de vous netting un nouveau jet de fun-mouche, ne cherchez pas plus loin que Jaws ici, il ne mordent pas .... beaucoup!
Plug and Fly, il suffit d'ajouter RX et Lipoly
construction simple et rapide
Construction robuste en mousse EPO
Utilise commune 2200mAh 3s Lipoly (non inclus)
Voler Poids: 700g
EDF: 64mm avec 39L Brushless Outrunner Motor
ESC: 25A w / BEC
Servo: 9g x 3
Your Own 4 canaux TX / RX
Batterie 2200mAh 3s Lipoly
colle de mousse de sécurité
Capacité ( mAh )
The wings and elevator are horrible, I don't see them lasting through one flight much less many, them the control horns are very cheap and will fell, save you money and buy something built better, this is more of a novelty item not a lasting flying plane/shark.First I find that the wings are very cheap and have a feeling they will fold during a flight, then there is no manual with it to let you know the correct CG, I guess I'll just stick a battery in it and see what happens, the body is one big ball of foam but the tail section and wings have no support and will break very easy.Very good un requin qui vols trs facile utiliser
trs trs bien super ractif trs surprenantLe requin volant et trs facile piloter il va super vite et trs impressionnant en vol
j'ai surpris tout le monde quand je les fais vol
pour moi le seul dfaut c'est la roue arrire on ne peut pas la dirig pour dcoller ou aterir
il vaut mieux le lancer la mainMaiden flight today and my first setup was aileron up/down 10mm, elevator 8mm, c/g 100mm behind the wing leading edge very nice and flying weight 895g (2200mAh 3S lipo plus 63,3g added lead). Flying went very well and it was easy to start with this setup. I will modify this plane for night flying too.This edf sharks seems to have more than enough power for regular flight and might even do a loop though not a tight one.
First thing to do, I changed out the 25 amp esc and used a 35 amp instead. This should be done if you want the esc to last longer and not quit in flight.
Rear wheel should be reinforced by taping the foam before gluing the rear wheel. Then add a stiff support to the rear of the rear tail fin to prevent it flexing during bad landing.
CG is like everyone said, 11cm from edge but it still feels a bit tail heavy if you're used to slightly nose heavy. It all balances out nicely with 2200ma 3s lipo pushed all the way to the front. Add a lipo buzzer to bring more nose weight too.
During take offs, it tends to pitch up a little, due to huge mouth intake, but once reaching flying speed, it stays level. Good nice floater.As review below, no instructions supplied with this model, ok assembly is very easy, however some info on C of G location would cost Hobby King nothing and would certainly help customers. As the previous review, I found the so called 24 hr help next to useless, i contacted them on a separate issue, took a week for an answer and when they did, they suggested an item that was out of stock everywhere.Well built body and lots of thrust with stock setup but awful electronics!
Neat plane, seemed to be flying well for the first few seconds of it's maiden flight until I lost thrust and had to hard land. I opened the access door and smoke poured out, the ESC was on fire!
I was using a 1800mah 3s LiPo...This plane will not even take off using the stock set up! It is very underpowered. The body is built strong as a tank, but all the fins are flimsy, You will need to upgrade the motor before you will be able to gain enough speed to lift off. Hand launching is about impossible as is. No rudder or steerable tail wheel, no instructions, no cg measurements, the elevator push rods are too short if you mount the control horns in the pre drilled areas. Sloppy waste of money. This plane is a novelty:(minus a crown for the terrible packaging! My shark has a big gouge across the nose from the idiotic cardboard edge it rests against inside the box. Just dumb. As an aside, I ordered some lipos with it, they were just thrown in to bounce around inside; not taped down or anything.
Bah. Not quite bad enough to return it. Just a warning to other buyers!