Folding Propeller W / Hub 19mm / 6x3 de l'arbre 2mm (1pc)

• Overall
• Quality
• Value

Crap

Sep 28, 2020

It came without set screw and half hole done. This way I put in my own set screw and went down until it stripped the thread. I had to make a hole on the other side to finally get a fix. That was crazy.

• Overall
• Quality
• Value

Passt nicht auf 2mm Welle Turnigy 1811

Jun 23, 2018

Hält nicht auf 2mm Welle Turnigy 1811, und zwar gar nicht, wackelt sogar.

• Overall
• Quality
• Value

Customer Rated

Dec 18, 2014

Cheap propeller. I had to drill out the hole and tap 4-40. A few flights and the prop was unbalanced (likely due to my inferior flying prowess and ground contact).

Don't put the final, pointy nose-cone on, nearly impossible to remove. Fly without if you ever plan to take the prop off in the future, since one nose-in landing will drive the nose cone on very tight.

For 1.76, you can't complain too much... as long as you have the tap and set-screws available.

• Overall
• Quality
• Value

Customer Rated

Feb 01, 2013

Fits strong and safe on 2.3mm shaft.
i am using it with speed 400 on 2s.
Recomended for planes (gliders) from 150 to 300 grams or up to 400g with stronger motor.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 12, 2012

Nice propeller. However, it does not come with a grub screw needed to attach the propeller to a motor shaft. The nose hub is about 3cm in diameter. There is some slack between the propeller and the hub.

• Overall
• Quality
• Value

Certified Buyer Rated

May 21, 2012

the center hole diameter is 2mm, so if u have 3 or more you should drill it little more

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 29, 2012

6x3,5 steht darauf und hat 16cm Durchmesser, Spinner ca. 29mm Hoehe ca.27mm

Die Spitzenverkleidung laesst sich nach Montage nicht leich herunternehmen die Blaetter sind gut ausgeformt fuer mittlere Belastungen und Drehzahlen 10g leicht

• Overall
• Quality
• Value

Customer Rated

Mar 21, 2012

dangerous product, two of them "exploded" in the first run. The blades flow away, the middle part was broken... I addition, the prop is very unbalanced, what a pity

• Overall
• Quality
• Value

Customer Rated

Jan 04, 2012

Simply don't understand why they don't make the hole for the shaft retaining screws.
Propeller itself is very good indeed, but no everyone have a cnc for perfect holes.
My holes are not perfect and so my prop is useless because it spin very badly.
If they make the hole will buy again because of its quality.

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 28, 2011

Esta bien para el precio que tiene