Le capteur Ampérage FrSky (FAS-100) peut mesurer le courant (A), la consommation d'énergie (mAH) et Power (W) lorsqu'il est connecté entre une batterie et ESC. Courant (A) et la puissance (W) seront affichés sur le FLD-02, tandis que le courant (A) et la consommation d'énergie (mAH) sera affiché sur le DHT-U. Le FAS-100 rapports Alimentation et Consommation sans capteur de tension externe et, en plus, peuvent être reliés entre eux pour signaler des tensions de cellules individuelles en utilisant le FLVS-01.
Plage de mesure: 0 ~ 100A
Maximum sécuritaire actuelle: 100A
Capteur consommation de courant: 33mA
Taux de rafraîchissement: ≥1Hz
Capacité ( mAh )
I have the FAS-100 connected to the Variometer and then the Variometer connected to my X8R via Smart-port. It works just fine.It can be hooked in line with the voltage sensor and relays back the power, consumption, current and individual and overall voltageDception. Le mien est arriv en panne. Lorsque je l'ai branch il s'est mis a fumer. un cas isol jespre
Very solid construction. PCB traces correctly designed to handle this power.
I think it's heavier than 24g declared but I don't have measured it.
Easy to install, just plug a connector directly on my D8R-II Plus (no sensor HUB) and I can immediately see Ampere in my FrSky FLD-02 (through DJT-II)Senzor k telemetrii FrSky na meren proudu do 100ASuperb item to use in all RC stuff. Cheap but top of the line system like Futaba. It just works. Buy with confidence.Dont buy this sensor it is a FAS-40 with shunt resistor that can only measure 40 Amps and can be purchased much cheaper than this else where.I just received two FAS-100 that didn't work. The voltage was working but no current. After a lot of trouble I opened the shrink wrap and discovered it is only and FAS-40 with FAS-100 label. The BATT and ESC positions are reversed between these two sensors. When I revesed my connectors I saw I had a working FAS-40. I notified Hobbyking and they said thanks and that is all. This is terrible customer support. They didn't even offer to send me the proper sensors I ordered! Not to mention they should send out an advisory to anybody who recently bought FAS-100 to warn them they could have a fire if they put 100 amps through the erroneous 40 amp device.PROBLEM WITH THAT WRONG CONFIGURED FAS ?? (SEE PICTURE "DEFECT FAS 100" IN THE FILES !
I have 2 Versions of these. The old one is working perfectly a FAS100. But the new one FAS 100 much smaller than the old one is not working from beginning. I opened a Request and make Videos for HK. They give the money back after control.
Than I opened the FAS100 and I was wondering, what I see. On the circuit board is written 40Ampere and not 100Ampere???? I bought a FAS100 !!! And a 40Amp FAS you cannot order/is not in the store from HK and not listed???? So from where is that product. Than I make recherches in Google and I find a FAS 40AMP in a specialised store for FR-SKY.
What is going on here with HK??? Is there nobody controling what they buy?Finally the version without plug. I have soldered a pair of XT90 to it. Great stuff for a great price.