H-King J-20 Glue-N-Go 650mm Foamboard Kit

• Overall
• Quality
• Value

I am currently interested in the Sukhoi Su-47, is that available?

Feb 15, 2020

I am currently interested in the Sukhoi Su-47, is that available?

• Overall
• Quality
• Value

J20

Dec 13, 2019

The only problem I had was with the under carriage. It didn't seem wide enough , so I improvised. Other than that very well made, looks good. Waiting for motor and esc. A 2700 KV brushless outrunner, powered by a 30amp esc. Should go vertical like a piece of cake.

• Overall
• Quality
• Value

Great kit

Nov 01, 2019

Great foamy.. Very realistic looking in the air.. the kit just needs some hinge tape added.. fit of the parts is incredible.. I definitely will be purchasing more even when there not on sale..

• Overall
• Quality
• Value

FANTASTIC

Jul 31, 2019

The best flying of the Glue-N-Go kits...easy to build and a lot of fun.

• Overall
• Quality
• Value

Great fun

Jun 06, 2019

good fun model easy to repair, instructions not very good.

• Overall
• Quality
• Value

My Least Favorite Glue-N-Go

May 21, 2018

My least favorite in the series so far, but I still have the MIG-29 to build though.
The reason I don't like this plane is because of the controls... All the other planes in the series have the elevons in the prop wash which gives you excellent control at low speeds. This airplane has the elevons on the wings outside of the prop wash so you have very little control when the speed is low. Flybys at 2 ft off the ground at a 45 deg pitch and near hovering speed is pretty easy with the F35, but not this.
I don't blame you for wanting to try this one out for $25, but I've be much happier with the other jets.

• Overall
• Quality
• Value

Lots of fun!

Apr 11, 2018

Easy and quick built little pusher prop jet. Gentle flight behaviour with the CG in the right location (3S 2200mAh Lipo most forward position), not too fast with 2306-2150Kv motor, 30A ESC and 6x4 prop. Stressless handlaunch and flying, slow landing speed. No expo or dual rate needed from my perspective. Looks nice in the air and provides lots of fun, overall great value!

• Overall
• Quality
• Value

Great little pusher

Mar 18, 2018

Any of the glue and go pusher jets are great , the 2826 2200kv is my motor of choice for all of them . If you do build one I would suggest you watch videos on c.g. locations . I use a apc 6x4 pusher prop .

• Overall
• Quality
• Value

Considerazioni

Nov 01, 2017

Le istruzioni di montaggio sono sbagliate. Gli alettoni si sono staccati al primo volo quindi ho messo le cerniere. I rinforzi in carbonio una volta infilati nelle sedi cambiano il profilo all’ala quindi suggerisco di allargare le sedi. Ho testato due motorizzazioni a 3 celle. Quella più divertente che rende il modello veloce è con il turnigy da 2200kv e elica 7x6 rimpicciolito di circa 1cm Per farla girare dentro la sede pre tagliata nel polistirolo.