hexTronik DT1000 Brushless Outrunner 1000kv

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 27, 2015

These are great motors - powerful and efficient - using these to increase the power on a number of models without breaking the bank or being power hungary

• Overall
• Quality
• Value

Customer Rated

Jan 29, 2015

I've had very good luck with these motors. I use them on my tricopter and they have lots of power. I have 10x4.5 props, pulling around 23 amps (per motor) at full throttle. I've had to replace the bearings in one after a crash, but that's to be expected. Make sure to secure the wires to prevent stressing the the connection to the stator, I used a little bit of 5 minute epoxy, worked great.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 28, 2014

???? ??? ? ??? ??? ???

?? ?? ?????

• Overall
• Quality
• Value

Customer Rated

Jan 22, 2014

good engine
pulls 1375 grams with Turnigy 2200 3s nano and an old wood 11 * 7
I have two of these and will buy more

• Overall
• Quality
• Value

Customer Rated

Nov 20, 2013

I use this motor in a Hk Club Trainer, with 10X6 prop and 40 ESC. I'm very satisfied with its efficiency, the plane climbs like a rocket and can performance any aerobatics with more than enough power. And furthermore a good price.

• Overall
• Quality
• Value

Customer Rated

Aug 28, 2013

Mine doesn't work at all. Quality visibly worse than my original motor from Mustang P 51 Art-Tech (same as HK Mustang).

• Overall
• Quality
• Value

Customer Rated

Apr 24, 2013

Este motor podria sustituirlo por El D4023 con Una 12/6 1500gramos esc 60 bis prrafo es sin ENTRENADOR Parecido al cesna 1,4 cm de envergadura.

• Overall
• Quality
• Value

Customer Rated

Feb 16, 2013

this motor is just amazing I am using it with a 12x6 apc prop and a 50A ESC and a 3s 3500mwh tons of thrust and power . and just near worm after a 8 minute flight thanks hobbyking its cheap and good quality and its power .

• Overall
• Quality
• Value

Customer Rated

Dec 20, 2012

my test results are
3s 12x6 57 amps i stopped a little over 1/2 throttle
where did you get 11x9 three blade 11.1V 20A from?
completely ripped off with this motor

• Overall
• Quality
• Value

Customer Rated

Nov 24, 2012

I only give 3 Crowns because.....I bought four and they came with NO information. V X A = W. your specs call for a 11.1V at 35A = 388 watts??? you say 500 watts??? at 14.8 V x 35 amps = 518 watts?? So.. what is it? I don't want to burn out my motors using 14.8V But I want the 500 watts!!