Illuminati 32 Contrôleur de vol avec OSD (Cleanflight pris en charge) NOUVEAU

• Overall
• Quality
• Value

INAV and MWOSD on an Illuminati32 Flight Controller for fixed wing

Aug 17, 2018

Flashed with Inav and MWOSD. Installed it on a flying wing, here is the result:
https://www.youtube.com/watch?v=ETHNMD-lfVs

• Overall
• Quality
• Value

Wowhat a price for 6DOF+baro+GPS+OSD unit..

May 26, 2018

Let me say thnx to HobbyKing for making possible to asemble own flying devices based on CleanFlight/BaseFlight source for this little Naze32 clone..
30.5 x 30.5mm mount hole spacing, included PWM, SBUS, PPM conection wires (JR servo single pins), comes with CleanFlight v 1.6.x bootloader in QuadX configuration but u can flash (via Chrome extensions) any vehicle configuration possible (Tri, QuadX, Quad+, BiCopter, DuoCopter, CCPM Heli, Y6, Hex+, HexX, Octo+, OctoX, Air, tTail, vTail, Gimbal...) have problems to connect it to newest v.2.0 (CleanFlight GUI) dowgraded to 1.6 solved the problem..
Since it has one UART and One SPI over serial, you can't use all 8 PWM pins (old obsolete transition protocol) and LED, GPS, Sonar or Buzzer pins, because signals goi through same channels (see manual under downloads). When using SBUS, PPM (signal over 1 single 3 wire cable) u can see GPS in OSD overlay and activate RTH, requires +5V DC from PDB or Ubec.
Those having problems with arming the RTF board, it must be leveled +/- 15° on ground, special arming sequence is needed (Throttle stick all the way down+rudder to the right) status LED, green solid:armed, red solid:disarmed, green fast flashing:bootloader, green slow blinking: connected, blue solid: ready to arm, blue blinking: firmware or bootloader error, blue fast flashing:restarting..
Only some of digital Micro USB cables work, some recharge cables don't, to configure OSD connect also the battery. While configuring ESC's (throttle range) take proppelers always off, hpy and safe flying..

• Overall
• Quality
• Value

ok

Apr 15, 2018

good board, dip switch is anoying but all work #1

• Overall
• Quality
• Value

Great FC

Apr 01, 2018

Have bought more than 20 of this FC's and never had any problem with them. This Flight controller is simple enough and very stable. I've been using this with QAV250, Robocat 270, SK450, Hercules 500 and also with X650F. I'm satisfied with this FC. For those who want to use PPM/SBUS, you just have to connect the signal wire to channel 1 (I'm using this with Turnigy Evolution and Turnigy 9X AFHDS 2A binded with Turnigy iA6C PPM/SBUS 8CH receiver).

• Overall
• Quality
• Value

Funciona con betafligth

Jan 14, 2018

Hola, esta controlador también soporta BETAFLIGHT. La flashe con el Naze 3.2.3. y todo a salido bien.

• Overall
• Quality
• Value

Probados

Jan 10, 2018

Los probé y van de maravilla con mis motores.

• Overall
• Quality
• Value

Excelente

Jan 09, 2018

Excelente controladora, facil de usar.

• Overall
• Quality
• Value

Excelente

Jan 03, 2018

Excelente controladora, facil de usar.

• Overall
• Quality
• Value

excelente

Dec 24, 2017

Excelente 100% recomendados.

• Overall
• Quality
• Value

Excelente

Dec 24, 2017

Excelente 100% recomendados.