The Holybro Kakute AIO V1.3 F4 flight controller comes with FC (flight controller), OSD (on screen display) and PDB (power distribution board) integrated into the same package. This makes it very simple and convenient to build a racing drone. The new F4 flight controller (STM32F405RGT6) has a 32-bit processor for extra processing speed. The ICM20689 (SPI) IMU gyro/accelerometer is mounted on vibration-isolating foam and can run up to 32kHz. And a dedicated boot button makes firmware flashing a breeze. OSD interface is highly customizable and can be setup to your requirements. There is an onboard blackbox with 128MB Dataflash chip for all your data logging needs.
No more pin headers to get in the way as all wiring is soldered straight to the board to reinforced, gold-plated solder pads for trouble free soldering.
Input voltage is for 7V to 42V which allows the board to be powered directly from a 6S battery pack. PDB maximum continuous current is 120A. Filtered voltage output of 5V 1.5A and 3.3V 200mA to power peripherals such as GPS, RX, FPV camera or LED strips. 5v/3.3v RX selectable.
The FC comes with Betaflight but is Cleanflight ready. BLHeli flashing is supported by the hardware. Betaflight OSD firmware is preloaded.
The Kakute AIO F4 V1.3 FC with OSD and Blackbox is the best package for your racing drone.
• STM32F405RGT6 32-bit processor
• ICM20689 (SPI) Gyro/Accelerometer
• 128MB Dataflash chip for Blackbox logging
• On-Screen Display (OSD)
• High quality, gold plated PCB
• Micro USB connector for programming
• High Voltage Input, 7 to 42V (up to 6S)
• Betaflight and Cleanflight supported
• BLHeli flashing supported by hardware
Dimensions: 35x43x7mm (includes USB in height)
Mounting Holes: 30.5mm square to center of holes
** Upgraded Current Sensor Version **