KS-SERVO 4ch FrSky ACCST Récepteur Compatible

• Overall
• Quality
• Value

Binding Voltage

Jul 01, 2018

Folks, I bought 6 of these receivers. Non wanted to bind with my FRSKY TARANIS XD9PLUS radio. I was initially using a Life 6.6volt battery. I then tried a single cell life battery with reading -3.6volts. All the Receivers then binded flawlessly with the transmitter.
If you having problems binding the receiver to your TX. try using a lower voltage.
After binding using the 3.6 volt battery it work fine. when i changed the battery to the 6.6 volts battery the indicator light started flashing. i have yet to flight test these receivers on my foamies

• Overall
• Quality
• Value

Binding DHT module

Oct 31, 2016

To bind with a DHT module in a 9X transmitter set the DHT switch to 2 Way. (Normal is 1 Way)

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 02, 2016

didn´t get it to bind and waiting for customer support hekping me as the manual isn´t really a manual

• Overall
• Quality
• Value

Customer Rated

Aug 02, 2016

This thing will not bind with the older DHT module, so is useless for me. Hobbyking, are you listening, and please don't delete this !!

• Overall
• Quality
• Value

Customer Rated

Jun 27, 2016

Works fine <300m, but starts to glitch at longer distances.
Very small and cheap, though i wont trust using in my DLG.

• Overall
• Quality
• Value

Customer Rated

Jun 15, 2016

Compre dos de estos receptores, uno trabaja excelente sin embargo el otro no activa el motor, los demas canales treabajan bien, creo que deberian mejorar el control de calidad y entregar a los clientes productos comprobados.

• Overall
• Quality
• Value

Customer Rated

Jun 11, 2016

I mostly build robots and rover-like vehicles. I usually connect my receivers to an Arduino and read CPPM. I've been using FrSky receivers (usually the D4R-II with the 27ms firmware), but I figured I'd give this cheaper knockoff a try. Within minutes I had this binded to my radio and sending 8 channels of CPPM into my Arduino code. I set the framerate to 21ms in my code. I'm not sure how the failsafe can be configured, but I easily have my code detecting signal loss by watching for the specific values that appear when the radio is off (all channels 127 except for throttle=0). I haven't tested the range yet. Assuming the range isn't terrible, this is going to save me a good $10/robot.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 09, 2016

Excellent value for money, It just works! No telemetry, but a solid connection to my 250 quad.

• Overall
• Quality
• Value

Customer Rated

Mar 31, 2016

I got 3 of those 2 of the 6ch and they work great all of them in planes and quads at the moment flying with no problem .

• Overall
• Quality
• Value

Customer Rated

Feb 23, 2016

My god, this thing is TINY.
No, really... It's TINY.
It has very good range. I tested it out to almost 750M before I gave up out of boredom. It binds easily to my th9x w/ DJT module. It binds easily to my Taranis x9d . It cleanly puts out 8ch of PPM with ZERO fuss. A , I will be buying more of these in the near future.

PS: I hope HobbyKing doesn't discontinue these any time soon.