Matek Systems F405-STD Flight Controller w/ Betaflight OSD & Blackbox

The F405-STD is fully compatible with both Betaflight and iNav.. It utilizes the ICM-20602 gyro which is connected via SPI to produce 32Khz gyro updates which detects the multicopter's motion for precision control. The onboard Betaflight OSD gives you the ability to view the On Screen Display information and allows you to set the flight controllers parameters via this display.

An important feature of the flight controller is that it has been designed to be stackable with the Matek FCHUB-6S to make a reliable, 6S compatible flight stack. If you do not want to use a 6S set up then this controller is also stackable with the FCHUB-VTX which will give you an excellent VTX with telemetry. The advantage of using a stack system is that if you have a serious crash and you break something then it is cheaper to replace the broken item rather than having to replace an all in one board. Another feature of this flight controller is that it has a built in blackbox with SD card slot to allow you to log as much data as you want.

The F405-STD is an. excellent, solid flight controller at a very affordable price which works with both Betaflight and iNav

Features:
• F405 MCU with ICM20602 32Khz gyro
• Supports PID loops at 16Khz
• Betaflight OSD
• 3 x LED's for FC status (blue/red) and 3.3V red indicator
• 6 x PWM/Dshot outputs without conflict
• 2 x 2812 LED outputs for loads of RGB bling
• 5 x UARTS are accessible
• 1 x group of 5V/G/S1/S2/S3/S4 pads for 4 in 1 ESC Signal/GND
• 4 x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
• 1 x pair 12C1 pads for use with magnetometer (iNav)
• 1 x side press button for BOOT(DFU) mode
• 1 x 16pin bottom mounted FFC slot for FCHUB-6S, FCHUB-VTX or FCHUB-W connections
• 36 x 36mm PCB with 30.5mm mounting holes

Specs:
MCU: 100MHz STM32F405GT6 (168MHz)
IMU: ICM-20602 (32KHz Max)
OSD: BetaFlight with AT7456E chip
Blackbox: MicroSD slot (SD/SDHC)
Baro: BMP280 (12C)
UARTS: VCP, UART1, UART2, UART3, UART 4
Support: Smartaudio and Tramp VTX protocol supported
Vcc: Lipo voltage input for battery detection only (scale 1:10)
SBUS: Built in inverter RX2 for SBUS input
RSSI: Frsky RSSI (PWM) input
LED: WS2812 LED strip signal
Beeper: Yes
Dimensions: 36 x 36mm
Mounting Holes: 30.5 x 30.5mm
Weight: 7g

Included:
1 x Matek F405-STD flight controller
4 x Rubber anti-vibration standoffs
2 x 0.5mm x 16pin 5cm FFC

Please note: A User Manual is available under the "Files" tab.