MCPX M0.3 1.5mm 9T pignon

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 28, 2014

pinion need for the 1220 motor for install in the xmods 1/28

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 05, 2014

alles bestens wie gewohnt! thanks

• Overall
• Quality
• Value

Customer Rated

Nov 29, 2013

works very good with my hp06v2 (1,5mm shaft).
i glued it with some loctite 609 (the green one) and it fits perfect.
thumbs up !

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 19, 2013

Gut fuer mcpx brushles motor!

• Overall
• Quality
• Value

Customer Rated

Feb 10, 2013

Hi all i have the same issue, i bought the 14000kv brushless motor for mcpx and the hole is fractionaly to large so it slips on and off. any ideas not sure ca will hold on a smoth surface that well under load.

• Overall
• Quality
• Value

Customer Rated

Dec 04, 2012

So I tried to put the 1.5mm pinion on this motor and it is too big!!! The specs say 1.5mm!!! W-T-F!

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 11, 2012

ich wrde es hier kaufen befor wo anderst viel teurer gut

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 02, 2012

Works so far very good and cheaper than in any other place - so what? Thanks HK!

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 20, 2012

This one is very important for MCPX as the brushed motor is not able to generate a lot of of thrust 8T so a 9T is recommended for high head speed as there is a whole lot of pitch to compensate that.