Le Mirage 2000 RTF est livré complet avec moteur brushless, paquet Lipoly, ESC et tous les servos installés. Assemblée de la Mirage aile, auvent et la queue peut être fait en 30 minutes. Inclure votre propre récepteur pour être prêt pour votre premier vol en moins de 40 minutes!Caractéristiques:
Fuselage Longueur: 930 mmEnvergure: 570mmVoler Poids: 510gSystème d'alimentation: ventilateur de conduit de 70mm avec 2826 brushless outrunnerBatterie: 3 cellules 11.1V - 1500mAh Li-Po
Inclus:Moteur: 2826 Brushless moteur outrunnerESC: 25AServos: 2 x 9gLithium Polymer Battery (valeur de $ 25.00USD)
I was a bit wrong. It can fly it on 4S 1300Mah with bigger air suction holes made on both sides and after adjusting or trimming the fan-think it wasnt fixed good -allmost no vibrationDucted fan is 65mm not 70mm!!!
I couldnt fly it on 4S 1550Mah and 40Amp ESC. Its not absolute opinion, maybe there were any my faults. Thrust about 600gNot enough power. should be sold with different ESC and battery, ofcourse more powerful or it wont flyhad a similar Mirage that wouldn't fly,so I cut holes in the sides 1.5" forward of the fan 1.5" high by 2" long now it will go vertical hope this helps
ALL who were dissapointed-Please put in
14.8volt 2200 li-poand away you go,go go
FanatasticShoooo-away up she goes.
N.B. Dont forget to put in 80 esc with built-in bec.
P.S. good price from this website.
I got one of these, fortunately I didn't pay for it. chances are like mine the fan not on tight. with the fan on the shaft properly. it flies ok.This is a sad excuse for a edf, Out of four attempted take offs I only got in the air once, Lumbered around in one circle with every thing I had to keep it from crashing. Not enough power to fly they should just give them away.The plane has the looks, has the sound and that's about all the good things.
The plane need's double the power and you would be very very happy,,,,,
THE BAD...... It would not get off the ground.....So me and a mate decided to hand launch it..... GROSSLY UNDERPOWERED........ it flew about 3 meters off the ground and we had no choice but to put it down,, the more we tried to turn the more it got lower to the ground,,,,, then we had to bring it down,,, broke the front end clean off.....Abit of glue and no probs.....
......GROSSLY UNDERPOWER...... all i added was a 6100 receiver like the instructions said..... BUT..... GROSSLY UNDERPOWER.......Excellent flying and very fast edf airplae