OrangeRx R614XN DSM2/DSMX Compatible Nano Indoor DIY Receiver with PWM & SBUS

• Overall
• Quality
• Value

fllying of nano

Mar 23, 2022

i have flown this on several craft at 1000 foot range.
no glitches

• Overall
• Quality
• Value

poor receiver

Dec 06, 2021

Rudder is moving with throttle input , doesn't like wifi signal !?
Is not linear

• Overall
• Quality
• Value

Good

Sep 10, 2021

Works good size

• Overall
• Quality
• Value

Correct

Jun 24, 2021

Le premier récepteur était impossible à binder en DsmX.
Il bindait en Dsm2, mais la led restait clignotante, et la portée était très faible.
Remplacé en garantie, le nouveau ne bind toujours pas en DsmX, mais en Dsm2 il bind correctement, et la led devient fixe, avec une portée correcte.

• Overall
• Quality
• Value

conforme a la commande

Jun 10, 2021

conforme

• Overall
• Quality
• Value

Great Little RX Board for DIY Projects.

May 12, 2021

Great micro receiver board for DIY projects that require minimal weight. I ended up using gold plated PCB pin connectors on mine to make connections a bit easier at the expense of a bit more weight, but one can simply solder direct to the board pin locations. 6 channels is also a nice number to have if you need extra channels of control. I use 4 because I use these for Throttle, Rudder and Elevator on micro rc airplanes of own design with individual separate servos and esc.
It's stand alone design makes this an attractive device, but would also be nice to have same board incorporated with 2 servos and esc already as a single unit similar to those used in micro helicopters or airplanes for those who would rather not have to solder their own separate components to it. I would not remove this original one from the market as options is what makes it more attractive.
I am giving it 5 stars because under the conditions I just described it is a nice little board. I am going to bypass a little glitch I noticed that when connecting a servo to it it sometimes would not fully connect with it and it was intermittent, this could be due to a bad solder joint since I have swapped servos I have to suspect it is a poor solder joint or bad connection somewhere in the circuit. I only saw this with one of 2 boards I tried.
I really like the layout and compact size.
MIA

• Overall
• Quality
• Value

A

Mar 13, 2021

Don’t know, havnttried it yet

• Overall
• Quality
• Value

great little micro receiver just what i have been looking for ,for years

Mar 02, 2021

as i have already stated lovely little job perfect for micro r/c brilliant for the price.

• Overall
• Quality
• Value

r614xn

Jan 29, 2021

connesso con cc3d il segnale e' instabile e i motori non si controllano.

• Overall
• Quality
• Value

Good litle rx

Jan 17, 2021

You have to solder your servos wire to tiny tabs, need good soldering skills