Devenez fournisseur Blog Nouveaux articles
S'inscrire

Prix total

0,00 €

Panier 0 Panier 0 Loading...

P-51D Mustang 1.2m EPO avec Auto Canopy (P & P)

Generating Links

P-51D Mustang 1.2m EPO avec Auto Canopy (P & P)

Prix:

Now save économisez 0,00 € 0,00 €

134,50 €
Déjà acheté Discontinued Product

Please continue searching for a similar product.
SKU:
P-51PNP
Livraison gratuite? Cliquez ici pour apprendre plus!

Cette Mustang OEB a une excellente finition à grande échelle, avec des lignes de panneaux, rivets, mât radio et les détails du poste de pilotage. La qualité des décalcomanies et de la peinture d'argent pré-appliqué vraiment finir l'apparence de ce modèle et si cela ne suffisait pas, il comprend également une des caractéristiques très uniques pour un modèle de cette taille. Un moteur de 800kV, servos et ESC sont tous pré-installé, il comprend également servoless électrique escamote une lame prop échelle 4 et performance 2 lame prop, le spinner est léger pour assurer qu'aucun des problèmes d'équilibre.

Voilà une liste impressionnante de fonctionnalités, mais maintenant la cerise sur le gâteau, le capot alimenté! Oui, en taxi vers la piste comme la vraie chose, le capot arrière, les vérifications avant vol, film de votre interrupteur sur votre TX et de regarder la diapositive de capot avant, vous êtes maintenant prêt à voler!

Ce modèle est également une bonne taille pour le transport, mais assez grand pour avoir une présence, tout ce que vous devez obtenir dans l'air est votre propre 6ch TX / RX et une batterie 2200mAh 3s Lipoly.

Spécification:
Envergure: 1200mm
Longueur: 1065mm
Voler Poids: 1300g
6 canaux (moteur, aileron, profondeur, direction, trains d'atterrissage, canopy alimenté)

Comprend:
4 x 9g servo (pré-installé)
escamote électriques Servoless (pré-installé)
moteur 800kV (pré-installé)
30A ESC (pré-installé)
canopée auto Actionné avec contrôleur (pré-installé)
4 10x8 de lame et de 2 lames 11x7 prop
Raccords, tournevis, de la colle et la feuille d'instruction.

Obligatoire:
6 canaux RX / TX
2200mAh 3s Lipoly

* Seulement 2.4GHz Radio Systems sont reccomended pour ce modèle

Télécharger une video

Inscrivez-vous pour télécharger des vidéos, s'il vous plaît se connecter ou s'inscrire

Sujets
Trier par
Sujets les plus récents
* Surnom:

* Votre réponse:


Veuillez saisir le texte affiché dans l'image dans le champ ci-dessous
*Code de vérification:
Annuler
Soumettre
Publier un nouveau sujet
* Surnom:

* Votre sujet:



Veuillez saisir le texte affiché dans l'image dans le champ ci-dessous
*Code de vérification:
Sujet du message

Inscrivez-vous pour écrire des critiques, s'il vous plaît se connecter ou s'inscrire

Docspace | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Sep 15, 2012

Nice looking plane, its a pity that its not as good as some people are reporting in their reviews



my honest opinion stay clear of this plane,its a lemon, unless you start from scratch



there are a number of issues from electronics, servos,retracts,cold soliders on engine terminals, servo extensions connected with bread bag ties,the wheel hubs are over tighten an cracked, props youll just laugh



engine an rudder/elev holders are made from 1.5mm perpex

what were they thinking



seriously take a good look at this produce HK its far from up to customer requirements



with all the technology at your finger tips, how about we use a bit of common since regarding the whole package



its not a $10 plane ,its $170, but it appears to be built like its only $10



the up side is, ive ripped all the crap out, an built a good plane with 4x quality servos, new retracts an alum wheels, upgrade the ESC to 60a an a 850kv motor

an aluminium engine mount an ply servos holders, carbon rod through the entrie length of the wings an fuselage, carbon hinges for all wing surfaces

Now this is a beautiful plane

Michael | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Sep 09, 2012

recieved mine just over a week ago; didn't bother with this plane when it came out as I was happy flying the FMS 1400 'Stang. However a new smaller car necessitated a slightly smaller plane, and this fitted the bill perfectly; shame that it looks it might now be discontinued? Hope not; after one flight I'm very impressed. Looks only slighty smaller than my current FMS 1400 Spitfire, but is much easier to fly.



Hand launching seems easy enough; only problems I had in flight were the battery cover coming off in mid air and a strong tendancy for the nose to rise. It didn't fly like it was tail heavy however; it just needed a lot of work to keep the nose from rising. Will set up some dual rates so that I can keep the same take-off ease then with a little less upward pitch in flight.



Looks great in the air, and contrary to what some other reviews have said, I found that (with the 2 blade prop) it was really easy to fly slowly on a 3 cell 2200mah battery. Only had it at 1/3rd throttle most of the time on a virtually windless day. Can't wait to get it in the air again :)

axememan | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

May 15, 2012

Nice plane,it has a few small issues and it likes to nose over.there is a circuit board in this for the sliding canopy and retracts.not sure if thats to protect voltage/current draw?the retracts move slow!to slow for me really and the canopy is kool.Both retracts and canopy are worm screw type which is kinda different.i think i would rather of had lights and flaps tho.This plane is a little under powered it flys fine but i am spoiled cause darn near everything i get gets a bigger motor and speed controller.it will keep up with a stock park zone t28.i went with the 2 blade prop.spinner is a cheapo and the battery slot is a bit snug and you have to fold your wires down into the fuse to get the hatch on.Looks Sweet in the air!!recommended

nickoedff18 | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Mar 28, 2012

beware, retract controll unit it not sold on hk! mine came defective out of the box, contacted cs, they sent me a new set of retracts.... no controll unit. been waiting well over a month since i got this bird, cs responds to emails after a minimum of a week. my advice would be to purchase a plane which hk stocks all spares for. other than this, the p-51 is fantastic both to look at and to fly, ive had around 50 flights with it, without any problems, all standard using a 2200 3s

nickoedff18 | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Mar 11, 2012

Hi guys, first off, this bird looks fantastic out of the box, assembly is very easy and only takes around 45 mins. I maidened it today using the supplied 4 blade prop, seemed to have plenty of go in it, very stable and needed no adjustment at all, 3 crowns for quality because my retracts don't work, cs is sending me a new set but! Although this is my first prop plane (only flown edf jets in the past) I cannot fault this planes flying characteristics at all! Think I'm going to have to purchase an f4u corsair also!

martskin | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Feb 16, 2012

recieved this plane a few days ago.made one flight lost eye contact and broke retracts.cuoldnt find glue that worked.im in winter.i fitted with skis.works super.i love this plane.i ordered another for backup.capt.crash.

martskin | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Feb 11, 2012

beautiful plane.well built.i luv it. just ordered a second one for backup.hk you have supper prices and service.thanks.harold.

martskin | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Jan 14, 2012

i just recieved this yellow bird.butiful plane.i cannot get the motor to run.i have a 9 channel hk spectrum tx &rx.all other controls work but not motor.can anyone help.harold.

Pedro | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Dec 17, 2011

Pay attention in the setting of the engine, because in my fourth flight, the screws that hold the engine loose, propeller damaged the fuselage and I still managed to land softly. But my model stayed with breakdowns in the fuselage, nose and side.

marre | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Nov 08, 2011

If you are expecting for replacement parts : forget it....
I've been waiting wings for 5 months ( and someone else for 8) because of a supplier failure.

Dive on grass: you have to modify retracts angle.

  1. 1
  2. 2
  3. 3
  4. 4
Téléverser un fichier

Inscrivez-vous pour télécharger des fichiers.
S'il vous plaît se connecter ou s'inscrire pour commencer à aider les amateurs maintenant!

Accessoires