Piaget Micro 3D Kit plan PPE w / Motor & ESC

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 07, 2012

Great little plane, just make sure you don't build it to heavy

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 01, 2012

Nice little indoor flyer , nothing for outside ,to light.

The kit build simple and fast .

The landing gear is to light,need's thicker fiber rod.The lighter you build the better it fly's .

Save on wire and plugs,solder directly and safe lots of wight ,cut the servo cable to length every gr you can safe the better it fly's.

Safe on shrinking tube not more than

strictly needed .

Safe wight is the magic word .

• Overall
• Quality
• Value

Customer Rated

Oct 27, 2011

Way too $ expensive for what you get with it.



Interesting, I see that you have to write a long review!!!!!!!!!!!



Compre, 'short & sweet'

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 06, 2011

This plane is not good. Very slimy, the motor becomes to hot after 1 minute of hovering. Landing gear is broken after 2 fly.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 22, 2011

Weak plane, be strengthened, the standard motor very fair

• Overall
• Quality
• Value

Customer Rated

Mar 01, 2011

Wow easy to fly,I thought it was going to be to quick twitchy! But it fly,s slow almost hovering on my first go! it was a bit fiddly to build ( being small) but strait forward the only mods I made were to build up the motor mount area with a little extra Epp and run 2x1mm carbon rods under the full length of the horizontal fuselage also the length of the ailerons trailing edge much More responsive its a great little plane!!!!!!!!!!!

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 11, 2010

After flying an array of expensive planes and helis this i've have more fun. What a ton of fun for a mere 40 buck plus a few bits.

Good job HK

• Overall
• Quality
• Value

Customer Rated

Apr 20, 2010

I finally completed my Stock Piaget with the standard motor 8x3" prop and 8 Amp Mag ESC, I waited for dead cam day and took it for a test fly. Everything was going fine until I opened the throttle only a bit over half and the ailerons started to shake up and down violently - (I didn't have the airbrakes on either) I used the platic hinges that came with plane and placed the where the manual said.

The result was a rather bad forced landing as the

• Overall
• Quality
• Value

Customer Rated

Mar 28, 2010

I have now had about 50 flights on my plane. It has been crashed a fair bit flying in a small space, I am amazed at how well it still flies with all the repairs ! It flies really well and even hovers with ease.The only issue is that it is very flimsy foam so the flexing effect the fling during hard turns or rolls. Other than that it has been a blast.

• Overall
• Quality
• Value

Customer Rated

Feb 13, 2010

Super little plane. Used 2.5g servos,hyperion 120mah 2s 25c pack,Ar6300RX, all up weight 55grams. Flimsy foam, reinforced a little with blenderm..flies well, hovers well. Good power. Thanks HK !