Prop métal CL-08A
This is a great high lift prop. Its 42 Dia with 3/16ths (4.7 MM) bore, its back-cut so unloads the prop and motor.These bad boys are quite good for the price. You will have to sharpen it but almost good enough to use unsharpened as the one that I got seemed to be balanced when I put it on a balancer. The shaft required for this is a 3/16" (4.76mm) so if you are using 4mm shaft you can stil utilise this by using a heat shrink (4-5mm) as a sleeve adaptor. Very easy enough to use so highly recommended.nice product from hobbyking thks hobbyking ssVery good prop for boats in the 25-31" range. Very nicely done and easy to balance. Use it for surface boats only.ok so most of the comments below say used it on the surge crusher - i bought one for mine and it doesnt fit the shaft! did all these people drill out the hole? info would be much appreciated. thanksrecvd mine..and try to fit my F1 hornet outboard..unfortunately its too big and need some adjustment..heheGood prop, good for my Genesis boat. I had to use a sleeve to go from 4mm to 3/16 (4.7mm aprox). The Genesis stock plastic prop had a sleeve in it. I used that after drilling out the hole in the new prop slightly.Needs to be sharpened and balanced. hole is exact diamaeterThese are 42mm, 1.2x pitch race props and we have great success using them on our hydro boats.
Cast quality is very good and material is strong too. Lot stronger than some other chinese brands found on the auction site....
Price is just right.konnte nicht Geliefert werden schade