Prop Saver w / 3mm Band

• Overall
• Quality
• Value

Customer Rated

Aug 02, 2009

Perfect choice for the money to safe propeller

• Overall
• Quality
• Value

Customer Rated

Jan 03, 2009

Screw head is to small. Very hard to tightened on shaft

• Overall
• Quality
• Value

Customer Rated

Dec 20, 2008

petit, lger, pas cher, trs pratique, je recommande!!

• Overall
• Quality
• Value

Customer Rated

Dec 19, 2008

Great product. Way better than breaking your prop.

• Overall
• Quality
• Value

Cheaper Than Making My Own!

Dec 11, 2008

I use to make my own prop savers. But when you add up the cost of the aluminum, the screws, the o-rings, and the time it takes to make them...it makes these a VERY good buy!



I usually add some of these to every order that still has a few grams left in my shipping bracket. They only weigh 3g!

• Overall
• Quality
• Value

Customer Rated

Dec 03, 2008

Light, cheap propsaver. With some mods. fit ok to GWS DD props.

• Overall
• Quality
• Value

Customer Rated

Nov 15, 2008

. / - . )

• Overall
• Quality
• Value

Customer Rated

Nov 14, 2008

I have had two of those. Also problems with the screws. The head get stripped. The screws will get loose on moisture conditions and if water will get inside the prop saver.

• Overall
• Quality
• Value

Customer Rated

Oct 24, 2008

Also... file your prop hub edges! I used an 8x3 -E APC prop with this and the sharp edges on the prop hub cut right through the black ring after several days! However, you can use cheap rubber bands looped back & forth around the screw heads, hey... it WORKS!

• Overall
• Quality
• Value

Customer Rated

Oct 24, 2008

The first 2 reviews are totally accurate! Plus is that it saved an 8x3 E APC prop about 8x now! Negative is that the screw stripped the threaded hole in the hub. The fix would be to run a 10-40 tap in there with cutting oil and replace screw.



As stated above: Trim your motor shaft, mount this right against the bell housing and file a flat in the shaft for the setscrews to settle into.