Grommet caoutchouc pour servos (10pcs / set)Diamètre du trou: 2.3mm
Bought these for a ds 520 tail servo on my t rex 450, with an a-lign aluminum servo mount. The height of the grommet and the brass "hat" is 4mm. Hat DO: 5mm, brass tube do: 3mm, di: 2.7mm, flange thickness: 0.4mm. The named servo has 4mm holes for grommet, and thickness of servo mount flange on the servo is 2.3mm. Perfect for my usage. Recommend.Grommet height when as on picture: 4mm, DO: 6.5mm, do:3.8mm, height of do part: 2.5mm, di: 2.8mm. Brass bushing height: 4mm, DO (flange diameter):5mm, flange thickness: 0.4mm, do:3mm, di: 2.7mm. Nice quality. I use them on a DS520 servo that I have on my T-Rex 450 with an Align aluminium servo mount. The DS520 has 2.3mm thick flanges for mounting, with 4mm holes for the grommets. I get just the right tension when tightened up so the servo is very rigidly held, but can still flex just a little. These grommets are perfect for this application! Recommend.The only place I could find them !can be used as damper for the control board against vibrationsprei leistung super weiter so.Always have a bag with this items in the box, sometimes the rubber grommets fail because they are too old. Then it is good to have replacements ready to mount, specially for this low price. Nice quality, nice price. They will fit for most standard servos.Use them or have your expensive servos wearing too soonesse serao uteis em minha caixa de campoMultipurpose set. Not only for servos.
Nice quality. Good to place on any Mid to standard servo placacement.