Devenez fournisseur Blog Nouveaux articles
S'inscrire

Prix total

0,00 €

Panier 0 Panier 0 Loading...

Skymaster Plug and Fly Trainer (Balsa)

Generating Links

Skymaster Plug and Fly Trainer (Balsa)

Prix:

Now save économisez 0,00 € 0,00 €

85,36 €
Déjà acheté Discontinued Product

Please continue searching for a similar product.
SKU:
9126000001
Livraison gratuite? Cliquez ici pour apprendre plus!

Le HobbyKing Skymaster est une construction traditionnelle, l'entraîneur de Balsa pré-couverte avec une différence, étant prise et voler, presque tout le travail a déjà été fait!

Le Skymaster est une construction rapide, même pour un novice, le moteur brushless outrunner, ESC et la plupart des servos ont été pré-installé, il suffit de suivre les instructions fournies et vous serez dans l'air en peu de temps! Être une feuille construction traditionnelle, le Skymaster est robuste et facile à réparer si vous avez un moment de oops, nous le savons, nous volons un presque chaque week-end! Le train d'atterrissage est un fil de piano approprié et est si dur qu'il peut gérer quoi que ce soit jusqu'à 4 roues "léger, même pour les aérodromes les plus désagréables!

Le Skymaster a beaucoup de puissance et gère superbement, si bien qu'une fois qu'un nouveau projet pilote a réussi à se familiariser avec les bases, un mouvement des taux passer et vous avez un petit modèle sportif brillant pour la maîtrise des manœuvres de voltige de base. Le Skymaster est un modèle de vol fantastique avec ce que certains «quelque chose» que seuls les modèles de balsa peuvent offrir, amusant et difficile avec une grande performance, cela est l'idéal polyvalent à la fois la piste d'atterrissage de club ou pour parkfly!

Caractéristiques:
Construction traditionnelle de Balsa avec robuste bâché Fuselage
Temps de construction rapide
Plug and Fly - Ajoutez simplement Reciever & Lipoly (non inclus) et Fly!
Piano dur Fil Undercarriage
Excellente manutention au sol
Plein Four Channel Control
voltige Capable
Beaucoup de puissance de la pré-équipée Brushless Outrunner
Savamment appliquée Couvrir avec un excellent schéma d'orientation

Spécifications:
Envergure: 1004mm
Longueur: 750mm
Voler Poids: 500g
Servo: 9g x 3
Moteur: 2822 Brushless Outrunner 1200kv
ESC: 20A w / BEC

Comprend:
Tout le matériel, Prop Saver & Prop
Instructions
Autocollants

A besoin:
Votre propre émetteur & Reciever 4 canaux
Batterie 1300mAh 3s Lipoly

  • Skymaster Plug and Fly Trainer
Télécharger une video

Inscrivez-vous pour télécharger des vidéos, s'il vous plaît se connecter ou s'inscrire

Sujets
Trier par
Sujets les plus récents
* Surnom:

* Votre réponse:


Veuillez saisir le texte affiché dans l'image dans le champ ci-dessous
*Code de vérification:
Annuler
Soumettre
Publier un nouveau sujet
* Surnom:

* Votre sujet:



Veuillez saisir le texte affiché dans l'image dans le champ ci-dessous
*Code de vérification:
Sujet du message

Inscrivez-vous pour écrire des critiques, s'il vous plaît se connecter ou s'inscrire

ear1pro | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Apr 03, 2013

Very good trainer plane, I was conversion it, using glow.10, without fuel 800gr, using MA 7x5 fly arround 25 minutes. good and stable flight even windy. It's my favourite plane!!!

Jani | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Jul 24, 2012

Really good trainer. Easy and very fun to fly. This is also hard to damage (I crashed it on trees several times and still goes on).

Be sure to check all motor screws before fly.

Digger313 | Acheteur vérifié

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Jun 22, 2012

I bought 2 of thoes, Very easy to set up and very for anyone to fly, very good for beginners.

Elmer | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Jun 17, 2012

Using a battery with 1300mhA 3s-15C can generated aprox. 19.5 Amps. This is very close to the capacity of the ESC (20A). I ordered one of the recommended batteries 1300mhA-3s-25C this could generated aprox. 32.5 Amps. Can this blow the ESC? Or is the max amps of the motor that should be below the max amps of the ESC (I read the rule of the 10pcnt)?
Thanks

Elmer | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

Jun 16, 2012

The motor set screws got loose and the motor flew off even before fly. Luck? I recommend locking fluid on these screws since the same issue has been reported by others. Hope, a factory fix for new models.

| Acheteur vérifié

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Jun 14, 2012

this is an excelent plane with oodles of power perfect for learning on. just set up as recommended.

shellby0351 | Acheteur vérifié

  • Overall
  • Quality
  • Value

Certified Buyer Rated

May 29, 2012

Surprisingly good build quality, fuselage made out of 3mm ply. Glued both the main wing and tail, setup all servos had to make some modifications to the rods exiting the rear of the fuselage, made adjustment to elevator to suit the tail wheel. Had to move the rudder servo as the length of the control rod to rudder was too short. Set up with OrangeRx R415 Spektrum DSM2 Compatible 4Ch Micro Receiver and Turnigy 1500mAh 3S and as the manual didnt state the CG, set up at 1/3 of the wing width to which was 53mm, flight times around 10 minutes with the battery as far up the front as possible and this will be good for the beginner; I would purchase a spare prop and O rings as I can see this being the weak point for the beginner. 10 out of 10 for this one

cxgiaco | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

May 23, 2012

Absolutely wonderful trainer! Came in the mail with other stuff, packed very carefully, with no damage. Construction was simple, though instructions are poor at best. Switched wheels per the HK suggestion. Proper CG placement required battery pack to be fully forward. I would suggest either 3S1P 2200mAh or 3S2P 1300s. Both Setups ran well, and put the CG in the sweet spot. No wing drop on stalls, takeoff in ~25ft on dirt (baseball diamond). Never had to go to low rates. May switch out the floppy prop adapter for better thrust response, but it makes sense for a trainer. Best value on the market for a balsa trainer.

coolzed | Acheteur vérifié

  • Overall
  • Quality
  • Value

Certified Buyer Rated

May 23, 2012

excellent avion. Facile a voler, beaucoup de puissance pour dcoller. Facile a assembler. S'assemble environ en 2hrs mme pour un dbutant. Le prix est vraiment interessant pour apprendre a voler et faire quelques acrobaties. Hobbyking est incontestablement un adversaire de taile dans le domaine des avion tlguid!!

Heliosphere | Acheteur vérifié

  • Overall
  • Quality
  • Value

Customer Rated

May 21, 2012

The Skymaster is my first balsa plane, after first owning foamies like the Bixler and Tek Sumo.



Out of the box I was very impressed with the quality. The covering looks great. Everything went together fairly easily, the only slight problem was that the main landing gear rods were slightly too long to fit flush with the fuselage. Had to get the Dremel cut-off wheel out and trim a few millimetres off for it to sit right.



One thing that is not good enough is that the manual doesn't mention a centre of gravity. Come on hobbyking that's a pretty important thing to include, especially for a trainer! I ended up entering all the measurements in an online CG calculator and decided on starting with a CG of 42 mm. It took a 1.8 Ah battery all the way forwards to balance at that point, so significantly more battery than the suggested 1.3. I'll try a 1.6 next to see how that affects flight.



I was a bit nervous with my first flight of a plane with wheels, but the skymaster made it easy. It flies great, feels a bit more "solid" in the air than the foam planes I've flown previously. Seems to be very forgiving on landings, a couple of mine have tested the landing gear, but there's a decent amount of spring in them to soak up the force. The 75 mm foam wheels worked great on the longer grass but I'm flying from.

  1. 1
  2. 2
Fichiers clients
Skymaster instructions Download [1807]
Téléverser un fichier

Inscrivez-vous pour télécharger des fichiers.
S'il vous plaît se connecter ou s'inscrire pour commencer à aider les amateurs maintenant!

Accessoires