Spinner pour plier Prop (Petit)
le style Collet, conviendra 2.3 ~ 2.5mm arbres moteurs
boulon de l'arbre Prop est 5mm
Nécessite une hélice en fonction des arbres 5mm.
Good quality, low price, perfect for small glidersThese hubs are definitely not 24mm diameter, more like 31mm.
Please change the specs or stock the correct size.
It is very frustrating to wait a week for the item only to find it's the wrong one and there is no economical way to send it back.
This is the second item I have purchased which has not been the same as the one shown in the ad!These hubs are garbage! The prop mounting holes are so close to the edge of the yoke that they break or elongate with props bigger than 7 or 8". Material is cheap and brittle. The collet will NOT grip a 2mm motor shaft! Their 2.5 and 2mm spec is pure BS.Diameter is 31mm and not 25mm.
Pin location looks a little bit fragile.
Fits "graupner 8x4.5" blades if you sand it a little bit.This spinner does not work on a motor with 2mm shaft as stated,because it will wobble like hell if you tourqe it down as much as you needed to make it stay on the 2mm shaft.I have tried on my AD-100L.The way i "solved" it was to put a thin shrinking hose on the shaft,making it around 2,3mm,then the wibration was gone.
\Patrik La good Spinner for smal planes.
but not the right for mine.Diameter is 31mm
Height is 25mm
Collet size 2.3mm
Blades 2mm hole, 6mm wide
Pins pitch 19mm
The 25mm diameter I wanted would have been great!!Look better than the folding prop in black plastic, more light too.
I will try to use it in a Mini Discus from Graupner with 7*4 prop and HXT 16g motor...
We'll see ^^.